FWS1649ZAS0 Frigidaire Washer - Instructions

Used a metal cooking spoon to pry open the lid, held it in place with a chain (mentioned in the tools required) and used needlenose pliers to remove the clamp on the old hose assmbly. Transferd that clamp to the new hose assembly and replace the (1) screw holding it in place. Closed the lid of the washer, and now it is like the problm had never existed. (Very easy fix, 1 of 10 on difficulty scale).

The repair was very simple. Just remove the fabric softener container at the top of the agitator and there was a cover with a little plastic "hook" on the top. Just take a pair of pliers and pull on the hook pretty hard and it pops off. Then using a 1/2" socket, loosen and remove the bolt and pull off the old agitator. Slide the new agitator over the "drive shaft" where the old one was, tighten the nut, put the cap back on, place the fabric softener tray back on, and I was back in business. Works great now.

Ordered the part online from PartSelect and it arrived Friday morning just 3 days later to my front door. Removed 2 screws, disconnected 2 wires, screwed the new part into place, plugged in the new wires and it still didn't work. Looks like my washer is just too old. So . . . I called PartSelect, explained everything. Three days later a full refund was in my bank account. Shop PartSelect with confidence. I will be back!

lifted up top panel unscrewed two phillips screws at bottom of front panel, lifted up and out and removed the panel exposing motor and belt .pushed in belt tensioner and removed belt.Then I slid the new belt under the tub pulley and rotated it until belt was on both the tub pulley and motor pulley,released belt tensioner and the job was over,

Just push the new knob into place.

Slip replacement knob on to selector switch shaft

We were at our condo in Florida and only had a limited time before we had to leave. After a local search we went the Internet and ordered our part and had it in two days. B Thanks. Bob and Marge

Had already pulled off the broken knob--actually it had fallen off in my hand. Opened the package, pulled out the knob and pushed it onto the knob shaft. Simple. Less than one minute.

By myself-less than 2min

Simply pressed it on. Nothing to it.

Pushed new knob on the piece that was sticking out. No tools needed, it was very simple to replace. Took ten seconds. Your service when we called about our problem was excellent, the part shipped in a very timely manner, and replacement was very easy. All in all, our dealings with your company have been great. Thank you.

Pulled the knob off, and put new knob on. So easy!!Should've done this sooner. Been using a broken knob, and it was a pain to turn on dryer. Now it's like it's brand new!!

Just pulled the broken knobs off and pushed the new ones on. Very easy!!!!!

We decided to see if this was the problem so we ordered replacement knobs, and IT DID!

Simple and your company provided the right part, amazing quick, at the best price and resolved our issue. Thank you!