FPSC2277RF1 Frigidaire Refrigerator - Instructions

Straight forward repair. Remove the four screws holding cardboard back. Remove the 2 screws holding the valve. Unscrew the water lines and unplug the electrical connections. I would caution that it would be wise to either take a couple photos or write down the order of connection. Even though it is somewhat color coded and the water lines are different sizes, a photo removes any confusion. My old valve had threaded connections using brass nuts and ferrules. The new valve has push in connections so you need to cut the ferrules off.. When cutting off the tubing, be sure to cut square. An angled or "squished" cut will leak when pushed into the fitting. Attach the valve to the refrigerator with 2 screws and replace the cardboard back and you're finished. While you have the back off is a good time to clean the coils. I left my fridge out and back off for a couple of ice making cycles so I could check for leaks (how I know the tubing needs to be cut very square). All in all, a very easy fix.

I followed the video and everything went smoothly. After pushing the pin in I pulled out the broken pin with needle nose pliers-very easy just like on the video. It took more time finding all the simple tools than the job itself-well almost!

very easy, make sure to watch the provided you tube video.

carefully removed retainer from old valve

Removed exterior housing, sliding old unit forward to release. New unit went in easily. Caution wires don't get pinched.

Remove old one and put in the new one

I put the new unit up to the old one to see exactly how it goes, took the 2 screws holding the unt off...Took the 3 water lines off with adjustable wrench, put back exactly the same way and it worked with no leaks

The part was easy to install and solved the problem! We had ice within hours. Thanks PartSelect!

Write down where tubing goes, wiring is color coded.

After sending PartSelect the info to their troubleshooting dept. about my ice maker, they recommended replacing the ice solenoid. I did so at a cost of $102. No change, turned out replacing the ice maker(did not purchase from PartsSelect) was the issue and works fine now.

So wasted $102. FYI the part took 6 days to arrive.

just slid them in and gently taped the pegs in

Replaced wall pins pulling center pins removeing set new ones replaced drawers. Damm Kids Busted the old ones it was easy to find your web site , parts and purchasse items as this was a new one It was diffacullt to use drawers

Use pliers to remove the broken support. Clear the remaining insert pieces with screwdriver/pliers and insert the replacement part.

took out the glass popped out the cover and put the new one on and put the glass on. DONE

The tabs were broken by kids it took 10 minutes to repair on all 4 tabs you have to remove the push pins completed to get the new tabs to fit right