FDB510LCS3 Frigidaire Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Lower spray arm had a hole melted from heater
Iwas hoping it wasn't a pump problem, I trouble shooted waht I could and determined that the loss in water presssure due to the hole was preventing any water to the upper spray arm. By replacing the lower spray arm for a small cost solved the problem and did not have to invest $400-$500 in a new dishwasher. The new gaskets were great .
Parts Used:
-
stephen from waltham, MA
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Water not entering dishwasher
Removed lower front panel and kick panel. The part was accessible from there. No need to pull the dishwasher out from under the counter top.
Parts Used:
-
Ernest from Sayville, NY
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers, Wrench (Adjustable)
Was this instruction helpful to you?
Thank you for voting!
door strike broken
Unscrewed dishwasher from cabnet. Removed nuts holding old strike in place. Put new strike in place and then reattached bolts to hold strike down. Followed by reattaching dishwasher to cabnet. Ready to use
Parts Used:
-
Janice from Conway, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
leaking aroung the door
-
cody from kalispell, MT
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Bad leak at bottom
Pulled old gaskets out, I could not get the bottom seal in until I used a mirror to see the slot it fit into, then it went right in, Tub seal was a brainless install.
Parts Used:
-
Wane from moville, IA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
broken spring on door
replacing spring is easy.but you have to disconect the water line to slide the washer out to get at the spring.service was exelant. part was deliverd next day.
Parts Used:
-
Ralph from Berlin, NY
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Screw drivers, Wrench (Adjustable)
Was this instruction helpful to you?
Thank you for voting!
original rack wheels where bent and upper wheels had melted
-
Sharon from South Park, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
wheel missing
2 wheels were missing and I replaced them in 2 seconds. The diagram online was a huge help!
Parts Used:
-
WILLIAM from KENNESAW, GA
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
Had to replace the drain hose (that I screwed up)
I already had the dishwasher removed for remodeling. I wrecked the drain hose myself. When I received the replacement it was a breeze to install.
Parts Used:
-
Steven from Wauwatosa, WI
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
Dishwasher Leaked at the door
I replaced the bottom gasket first. It was kinda of tricky after pulling the old one out. The video on how to install it was very helpful and the installation took about a minute. The tub gasket was easy and fit right in. I just had to cut off the extra so it would fit in.
Parts Used:
-
David from Middletown, DE
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!