Quick Question!

Have you ever purchased from PartSelect.com before?

Models > FAFW4221LW0

FAFW4221LW0 Frigidaire Washer - Overview

Get Parts and Repair Help for FAFW4221LW0

If you know the washer repair part you need, you can browse the list of all parts on the FAFW4221LW0, or you can search by name or part description. You can also find your part by where it is located on the FAFW4221LW0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for FAFW4221LW0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$7.21

Door Strike

This is a strike for washing machine. This part activates the door switch.

$73.15

Door Hinge with Bushings

This is a door hinge with bushings and works in conjunction with your washer. The purpose of this part is to attach to the outside of the front door panel to help with the lid opening and closing properly. The hinge will fasten the front panel of the washing cabinet to the lid of the washer. This piece is roughly 9 inches long, almost 3 inches high, and roughly 2.5 inches wide. The reason for needing to replace this part is if your lid/door will not open or close properly, which may lead to leaking.

$189.59

Bellow Kit

Also known as a Door Boot Seal and is used in front load washers. This part is used to keep the clothes inside the tub during the wash cycle. The folds in the bellow allow the tub ...

$6.65

SCREW

$6.86

SCREW

Sold individually.

$46.55

Dispenser Drawer Handle Frame - White

$20.72

Spring-Held Bellow Clamp

$35.30

Dispenser Drawer

$15.47

LEVELING LEG

$4.74

SCREW - M5 X 0.8 X

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Old Bellow Ripped

  • Customer: Peggy from New Castle, PA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 221 of 303 people found this instruction helpful
remove top of machine by removing 3 screws along the top edge in the back of your machine and then sliding the top back and up. Then loosen the screws holding on the control panel enough to get to the 2 screws at the top of the door panel. Next remove bottom panel by removing 2 screws along bottom edge then pulling it free from snaps. Then along the outside ... read more

replace door striker

  • Customer: Berend from New Haven, VT
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers
  • 58 of 61 people found this instruction helpful
The striker is really easy to replace. Remove 2 #3 phillips screws, replace the striker part, and tighten the screws.

It got more complicated when too many striker tips broke off inside the latch assembly and prevented the tip of the new striker from going inside. To get at the latch assembly, I had to remove the big rubber gasket that connects ... read more

Door Striker broke off

  • Customer: Christine from Troy, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 22 of 26 people found this instruction helpful
Replaced the old striker with the new one in about 5 minutes. Just needed a phillips screwdriver. Unbelievable how hard it was to find the part at local store...much easier to order from partselect. If I break it again, I will be all set. Part cost $7 vs repairman visit at a cost of at least $200 - - was worth the effort. read more