F8958W0 Roper Range - Instructions

Someone did the repair for me.

just a matter of replacing the lint filter

Time was do to the fact that I replaced two elements! I turned off the power to the braker box, unplugged the stove and removed the screw holding the element plug in, removed the part, and cut the wires where they were clean looking (not damaged by smoke or the arch) I then stripped the wire and took the new part and twisted the parts together with the caps and then put the heat shrink on and used the blow dryer on them, attached the part to the bracket and screwed it to the hood of the stove plugged the burner in, plugged in the oven and turned on the power tested it worked, did the same for the next burner and yes mind you I am a woman it was very easy to do.

Removed the original burner element sockets and replaced with parts provided in kit. Instructions were simple and easy to follow, problem completely solved in 20 mins!

First I lifted the cooktop out of the countertop & removed the screws so I could access under the burners.Then I cut the wires for the old plug-in block & then stripped the wires.Next I connected the new wires with the wire nuts & then used a lighter to shrink wrap the wire nuts.Then I screwed in the new block & re-installed the screws for the cooktop.I put in the new burner & it worked just like new.

Removed burner and tray. Removed burner connector from stove top using screw driver.
Removed existing heat shrink and wirenuts.
Installed new connector - wire nuts and heat shrink. Used lighter to shrink.
Took 20 minutes.

Removed old block , cut off wires , used new wire nuts, heat shrink , supplied with parts , job done lowered range top went fishing ...

First I removed the one screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires.

I pulled the old filter out and replaced it with the new one.

Replaced the broken one with the new one which arrived only 2 days after I ordered it. I was very pleased with the service!

Inserted the new one

After struggling with different methods for removal of the guide rail stop, I noticed a video on the screen with the part number PS2099534 shown. The video clearly described the process. Both guides were removed the dish rack was replaced, the old guides reinstalled in less than 5 minutes.
Many thanks for the helpful video.

The repair was simple. The filter arrived in just a few days after i ordered it. All I had to do was to remove the old lint filter and replace it with the new one. At the time i received the new lint filter I was a bit concerned because the lint filter was a bit bent being shipped in a box that was a git to small for the filter. That ended up not being an issue in the long run. I would recommend part select anyone needing parts.

gene mille

Replace the connector and bracket, spliced the wires, put heat to the schrink wrap and I was done.

I raised the stove top, read the instructions to my son while he did the work, then I lowered the stove top, installed the burner, and it worked like magic.