DU8900XT2 Whirlpool Dishwasher - Instructions

I simply snapped off the old broken roller set and snapped on the replacements. No tools were even needed and now the rack rolls smoothly on all wheels! This has encouraged me to try other
repair projects.

after that every thing went very well

The 1/4 inch impeller bolt to shaft would not budge with a nut driver so I had to use a ratchet to loosen it. I could not hold the drain impeller with an adjustable wrench so I had to use a vice-grip. This still did not loosen it so I used an oscillating power saw to cut away at the bottom of the drain impeller being careful to only cut so deep, I didn't want to cut into the motor shaft. Once I had cut some grooves into the drain impeller, I could break it into pieces and remove it. Upon reassembly I tightened the 1/4 inch bolt with the ratchet.

Took the old one off and replaced it with the new one we received from you. It was great because we received the part just in time to do the Thanksgiving dishes! Thanks PartSelect.

Replaced broken door spring and retainer:
1.To gain access - removed two retaining screws in lower front panel below the door. Lifted panel off hooks in toeplate.
2.Replace spring and retainer - note how retainer fits into spring and how spring is attached to door hinge. Rehook spring and retainer in same slot as before. There are two springs. If only one is broken, let the unbroken spring be your guide in replacing the new one.

I prayed old wheel assembly’s off with the claw end of a claw hammer. Carefully snapped on the new assembly’s which were a little tricky to align. Went well, took about 15 min.

I pulled the basket out, pulled the cap and connector assembly off with ease, no tools needed, it comes right up, and put the new one on. Put the basket back in and it works great now!

Reassembled lower access covers using the new screws purchased from parts direct, perfect fit replacement. Hardest part remembering how they fit Dishwasher.

One day after placing my order, replacement wheels arrived. I used a screwdriver to pop each (4 total) old set of tandem wheels off the basket basket and poped each new set on.

Removed old wheels, unclipped. Clipped in new wheels.

simple, simple, simple ! popped off the old ones, snapped on the new ones. Thanks !

I snapped the old ones off & snapped on the new ones. It couldn't have been easier!

i used a screwdriver to pry off the old wheels then snapped on the new ones.
This was the easiest repair I have ever made on an appliance.

installed a new rack

Popped the old ones off and replaced them with the new set. No tools needed. Just clipped the new ones on.