All Installation Instructions for Whirlpool Dishwasher DU3003XL0

dry rotted/missing plastic wheels on bottom dish rack

Popped the old ones off and replaced them with the new set. No tools needed. Just clipped the new ones on.

Parts Used:

Tandem Rack Rollers - Set of 4

Ned from Mauldin, SC
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Dishwasher Not Heating top rack wet dishes and heating rod looks rusted

It took all of 30 minutes from beginning to end remove the old parts and replaced them and run a diagnostic test before I could wash dishes. The parts were exact and Parts Select has always provided the right parts, shipped fast and never disappointed me.

Parts Used:

Rubber Washer

Jose from HOUSTON, TX
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Wrench (Adjustable)

1 person found this instruction helpful.

Was this instruction helpful to you?

lower rack started to rust through coating

Since there were no printed instructions, we looked at the photo schematic.
Reassembly using the photo was easy by putting the old rack alongside the new one and adjusting the new rack spacing to match the old one.
We also had new wheels which snapped on.
We were delighted to repair and replace this good, older dishwasher rather than purchase a new one!

Parts Used:

Lower Dishrack Kit

Carol from St Johnsbury, VT
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

3 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Replaced four lower rack on a whirlpool dishwasher.

I prayed old wheel assembly’s off with the claw end of a claw hammer. Carefully snapped on the new assembly’s which were a little tricky to align. Went well, took about 15 min.

Parts Used:

Tandem Rack Rollers - Set of 4

James from Shreveport, LA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

All rollers missing on lower rack of dishwasher

The brackets that held the original wheels were still on the rack. They were easily pulled off the rack. The new assembly did not look like the original part. It was not difficult to see how they fit onto the rack. The only caution is to press the top part of the new assembly onto the frame before snapping the rest of the new piece into place.

Parts Used:

Tandem Rack Rollers - Set of 4

Raymond from SPRINGFIELD, IL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

dishwasher bottom basket wheels came off

One day after placing my order, replacement wheels arrived. I used a screwdriver to pop each (4 total) old set of tandem wheels off the basket basket and poped each new set on.

Parts Used:

Tandem Rack Rollers - Set of 4

Jack from Tampa, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Worn wheels on lower rack

Removed old wheels, unclipped. Clipped in new wheels.

Parts Used:

Tandem Rack Rollers - Set of 4

James from Jupiter, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Soap door wouldn't open.

I looked online to see a video. Dad to pop lid off soap dispenser. Slide a plastic part to the left n the spring slide off. Video showed how to place prongs on spring . Then had to lift the upper part of spring to lift onto plastic part of soap dispenser. That was it.

Unfortunately it still doesn't work. I asked Ina email to your company for any suggestions, No reply.

Parts Used:

Dishwasher Detergent Lid Spring

Anthony from CLEVELAND, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

THE LOWER RACK WAS CORRODING IN SPOTS AND WAS RUSTING

THERE WERE NO INSTRUCTIONS INCLUDED, COULDN'T FIGURE 0UT HOW TO INSTALL THE NEW ROLLERS ON THE NEW RACK FINALLY INSTALLED THE OLD ROLLERS ON THE NEW RACK AND THEY WERE MUCH EASIER TO INSTALL I DONT UNDERSTAND
WHY THE NEW ROLLERS WERE THE SAME AS THE OLD ROLLERS
EXCEPT FOR THE COST.

Parts Used:

Lower Dishrack Kit

JOHN from JUPITER, FL
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Lack of assembly instructions

YouTube was very helpful
New racks works better that way expected. Rearrange ment maximized loading

Parts Used:

Dishrack - Rack Only

Lower Dishrack Kit

Ray from Lufkin, TX
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

my old lower dishwasher rack was rusted out and some parts broken.

Snapped on the rollers, removed the center part from the old rack that sprays the water and snapped it on the new one. We then bent the back row down so it would acomodate my larger items. My old rack had that feature. You could either have the rack up or down. Now l
ooks beautiful and works perfectly.
Could have used some directions though.

Parts Used:

Lower Dishrack Kit

Kathy from ELGIN, IL
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers

1 person found this instruction helpful.

Was this instruction helpful to you?

Bottom tray wheels would catch on old door gasket making it difficult to remove and insert.

Followed the exellent instructions, the flange kit really solves the problem of lower rack wheel catching on the seal. Superior replacement parts compared to previouse repair two years ago.

Parts Used: