All Installation Instructions for Whirlpool Dishwasher DP920PFGY2

Remodeling a house and front panel on dishwasher was bent and needed replaced. I just measured panel and ordered without a model or part number. Was so lucky the panel fit perfect.

Just took old panel off and went side to side and then slide panel under front trim. Of course it was easier because the bottom door trim was off and now I have to find that replacement part. Not having any luck with that!

Parts Used:

Dishwasher Door Panel Insert

Sylvia from WHITESBURG, KY
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Lost Screws from lower access covers for my Dishwasher

Reassembled lower access covers using the new screws purchased from parts direct, perfect fit replacement. Hardest part remembering how they fit Dishwasher.

Parts Used:

Screw - 8-18 x 1/2

Johnny from LEVITTOWN, PA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

1 person found this instruction helpful.

Was this instruction helpful to you?

Lost the cap to the Rinse aid container in door

Ordered part, recieved part package, opened package, inserted screw cap rinse aid tank cover, twisted to close. Job completed. Time required about 15 seconds from opening package. Service was excellent and accurate. Thank you.

Parts Used:

Rinse Aid Cap

Bruce W from WESTERLY, RI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Soap door wouldn't open.

I looked online to see a video. Dad to pop lid off soap dispenser. Slide a plastic part to the left n the spring slide off. Video showed how to place prongs on spring . Then had to lift the upper part of spring to lift onto plastic part of soap dispenser. That was it.

Unfortunately it still doesn't work. I asked Ina email to your company for any suggestions, No reply.

Parts Used:

Dishwasher Detergent Lid Spring

Anthony from CLEVELAND, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

original dishrack had become rusty

installed a new rack

Parts Used:

Lower Dishrack Kit

Tom from Peoria, AZ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Dishwasher Not Heating top rack wet dishes and heating rod looks rusted

It took all of 30 minutes from beginning to end remove the old parts and replaced them and run a diagnostic test before I could wash dishes. The parts were exact and Parts Select has always provided the right parts, shipped fast and never disappointed me.

Parts Used:

Rubber Washer

Jose from HOUSTON, TX
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Wrench (Adjustable)

1 person found this instruction helpful.

Was this instruction helpful to you?

Water would not stop flowing into dishwasher causing it to overflow on the floor

This is a portable dishwasher.. so first I turned power off and connected water line. When I turned the water on I noticed the water would flow into the dishwasher. This is not suppose to happen. This told me it was the flow valve. I disconnected water line, turned power off and removed bottom plate, removed screw holding valve on, removed water hose and output hose and unplugged valve. Then installed new valve. Turned water on to test and water did not flow into unit until cycle started. So simple. Problem solved in 10 minutes.

Parts Used:

Dishwasher Water Inlet Valve

Dino from WURTSBORO, NY
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Rack Was Rusting Out

Kit didn't have the center conical piece. Easy to switch tho. I am impressed at the speed of which the part arrived.

Parts Used:

Lower Dishrack Kit

William from Rochester, IL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

lower rack started to rust through coating

Since there were no printed instructions, we looked at the photo schematic.
Reassembly using the photo was easy by putting the old rack alongside the new one and adjusting the new rack spacing to match the old one.
We also had new wheels which snapped on.
We were delighted to repair and replace this good, older dishwasher rather than purchase a new one!

Parts Used:

Lower Dishrack Kit

Carol from St Johnsbury, VT
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

3 of 7 people found this instruction helpful.

Was this instruction helpful to you?

The Cutter Spring was totally disfigured and pulled apart. Not functional.

Repair went exactly like the video i watched online. Perfect

Parts Used:

Drain and Wash Impeller Kit

Aubrey from BERKELEY LAKE, GA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers, Socket set

1 person found this instruction helpful.

Was this instruction helpful to you?

my old lower dishwasher rack was rusted out and some parts broken.

Snapped on the rollers, removed the center part from the old rack that sprays the water and snapped it on the new one. We then bent the back row down so it would acomodate my larger items. My old rack had that feature. You could either have the rack up or down. Now l
ooks beautiful and works perfectly.
Could have used some directions though.

Parts Used:

Lower Dishrack Kit

Kathy from ELGIN, IL
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers

1 person found this instruction helpful.

Was this instruction helpful to you?

NEW GASKET

I USED A PLUMBER

Parts Used:

Dishwasher Door Gasket - Gray

George from TEMECULA, CA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Lack of assembly instructions

YouTube was very helpful
New racks works better that way expected. Rearrange ment maximized loading

Parts Used:

Dishrack - Rack Only

Lower Dishrack Kit

Ray from Lufkin, TX
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

i had a leak under the dishwasher when the pump turned on.

I replaced the seals per the video instructions.

Parts Used:

Drain and Wash Impeller Kit

Walter from KINGSPORT, TN
Difficulty Level:
Really Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Screw drivers, Socket set, Wrench (Adjustable)

1 person found this instruction helpful.

Was this instruction helpful to you?

throwed water out under the door

Did not use the new parts. After removing the spray arm, found a screw out of place. Put the seal ring back in place and the screw back in the hole. Machine works like new.

Parts Used: