CSK30DRBAAA Hotpoint Refrigerator - Instructions

removed 2 screws and installed new rail with 2 screws 5 min

First take all your junk off the shelf (with the broken rail of course), take the glass shelf off. Remove screws (phillips). Throw away old rail. Replace new rail, tighten screws. Replace shelf, replace junk. You're done.

I removed food from shelf over crisper drawer, then removed shelf and crisper drawer, removed two phillips head screws in right side rail and replaced rail.

Easy as 1-2-3

Removed each drawer and removed two screws for each rail. Disposed of old rails. Installed new ones using the screws removed from old rails. Put drawers back in and VOILA! Crisper drawers that work! AMEN PARTSELECT!

removed drawer, unscrewed old slide, screwed on new slide, voila! finished! I was very pleased with PartSelect -- ordering was easy, the correct part came quickly, and packaged very well. All of life should work so smoothly!

My husband took out the old icemaker in about 5 minutes. The new icemaker was a perfect fit even though the refrigerator was >10yrs old. The only difficult part was the plug extension that was needed so that it would fit into an older appliance. The part was included, it just made the cord about 3 inches longer than it needed to. After working with it for about 20 minutes we were able to fit it on the back side of the icemaker. Now it works great!!

Unplugged fridge.Removed 2 screws holding a panel. After panel removed took off old fan and inserted new. Quite simple.

I had to remove the food off the shelves, then i had to had to remove the shelves. I then took the refrigerator door off. I then removed the bins and removed the broken drawer rails. I then cleaned the area where the bins were. I then installed the new rails and put back the bins. I then reinstalled the refrigerator door and all the shelves. Last was putting all the food back in. Everything went very well.

Unscrew the two screws with a screwdriver and replace the new slide rail with the same screws.

I took out the drawer and the glass shelf.
All that was required after that was to unscrew the old part and replace it with the new one using the old screws. Very easy!

I used a short Phillips screwdriver to remove 2 screws that held the broken left slide rail in place. Then I screwed the new part in place. Really, really easy!

I removed the 2 screws that had held the cracked drawer slide rail. The new slide rail fit perfectly. I screwed it in using a phillips head screw driver and the drawer slid back in place. Very easy!

removed two screws removed bad part installed new part.

First I removed the two screws that held the slide in place. I then pulled the slide out and lined up new slide and reinstalled the screws.

1) The large drawer is first removed from the guide that remained on the side wall.

2) Removal of the light shield from the rear of the glass shelf to facilitate glass shelf removal by lifting the rear edge of the glass and remove it.

3) Unscrew two phillips head screws holding the remaining pieces of the plastic guide to the interior side panel of the fridge.

4) Examine the replacement guide and insure that the nylon guide and stop parts are clicked into place. If unsure, look at the guide on the other side to ensure that both are present and completely seated before installation of the replacement guide. (These usually fall out of the guide during shipping and should be in the bag with the guide!)

5) Once the guide is outfitted with the nylon guides, secure the new guide with the two phillips screws and DO NOT over tighten, remember you are dealing with plastic guide and steel screws going into a steel cabinet.

6) Re-install the glass shelf, followed by the light shield and finally the large drawer which should slide out smoothly to the stop and back closed without any drag.

7) A successful installation usually includes giving the drawer and glass shelf a good cleaning that probably could be done to the entire fridge side of the unit.