CSG28DHCCWW Hotpoint Refrigerator - Instructions

removed 2 screws and installed new rail with 2 screws 5 min

First take all your junk off the shelf (with the broken rail of course), take the glass shelf off. Remove screws (phillips). Throw away old rail. Replace new rail, tighten screws. Replace shelf, replace junk. You're done.

I removed food from shelf over crisper drawer, then removed shelf and crisper drawer, removed two phillips head screws in right side rail and replaced rail.

Easy as 1-2-3

Removed each drawer and removed two screws for each rail. Disposed of old rails. Installed new ones using the screws removed from old rails. Put drawers back in and VOILA! Crisper drawers that work! AMEN PARTSELECT!

removed drawer, unscrewed old slide, screwed on new slide, voila! finished! I was very pleased with PartSelect -- ordering was easy, the correct part came quickly, and packaged very well. All of life should work so smoothly!

My husband took out the old icemaker in about 5 minutes. The new icemaker was a perfect fit even though the refrigerator was >10yrs old. The only difficult part was the plug extension that was needed so that it would fit into an older appliance. The part was included, it just made the cord about 3 inches longer than it needed to. After working with it for about 20 minutes we were able to fit it on the back side of the icemaker. Now it works great!!

Unplugged fridge.Removed 2 screws holding a panel. After panel removed took off old fan and inserted new. Quite simple.

I had to remove the food off the shelves, then i had to had to remove the shelves. I then took the refrigerator door off. I then removed the bins and removed the broken drawer rails. I then cleaned the area where the bins were. I then installed the new rails and put back the bins. I then reinstalled the refrigerator door and all the shelves. Last was putting all the food back in. Everything went very well.

Unscrew the two screws with a screwdriver and replace the new slide rail with the same screws.

I took out the drawer and the glass shelf.
All that was required after that was to unscrew the old part and replace it with the new one using the old screws. Very easy!

I used a short Phillips screwdriver to remove 2 screws that held the broken left slide rail in place. Then I screwed the new part in place. Really, really easy!

I removed the 2 screws that had held the cracked drawer slide rail. The new slide rail fit perfectly. I screwed it in using a phillips head screw driver and the drawer slid back in place. Very easy!

remove screws insert new rail

The drawer slide broke and I just removed the 2 screws that were still in the side of the refrigerator. I then screwed the new drawer slide in the same holes and it was done!! Simple, simple....even for me, the housewife.... ; )

removed two screws removed bad part installed new part.