CS30 - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
fuel line leaks
As others have said , simply remove old tank and tubes and replace in reverse order., being sure tube from filter goes to primer bulb.
Parts Used:
-
john from Massena, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
14 of 34 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
bearing set up in lower shaft.
-
Irvin from BURR OAK, MI
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
3 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
THE DRIVE SPLINE IN THE MIDDLE OF THE SHAFT WOULD NOT ENGAGE
-
JAE from MILL HALL, PA
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
3 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Would not run
Replaced carburetor, fuel lines, fuel filter and spark plug all from parts select. Very small amount of carburetor adjustment. Worst part was replacing fuel lines into fuel tank. Sharpened edges and put dawn dishwashing detergent on them and pulled them through tank with needle nose pliers! Worked like a charm!! Spent only about 45 minutes.
Parts Used:
-
Herbert from SPANISH FORT, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Socket set, Wrench set
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!