All Installation Instructions for Frigidaire Refrigerator CFHT1513LZ8

Easy and simple!

had it done in 5 seconds!!

Parts Used:

Door Rack

Mordechai from Brooklyn, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

replacing broken door racks

Super easy it took no more than 5 minutes to replace the fridge door racks. Starting from opening the box when it arrived to closing the fridge door with the new racks in place. no tools needed, except a knife to open the box.

Parts Used:

Door Rack

francine from brick, NJ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

The hole on the handle mounting block was too low

I had to loosen the screw holding the mounting block and increase the hole size to fit the screw on refrigerator

Parts Used:

Handle Mounting Block

Sadrudin from SAN DIEGO, CA
Difficulty Level:
Difficult
Total Repair Time:
30 - 60 mins

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Handle borke into 2 piece

As I was aware hot install it, bec a couple of days back, the handle pop out of the lower screw shaft. The easy steps is put the lower part first, keep the handle diagonal to the door, once the lower screw is fit into the shaft, turn it to right to place the holes on the door holes and just jack in the screw.

Its pretty easy.

Parts Used:

Door Handle

Amit from Glendale, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

2 of 6 people found this instruction helpful.

Was this instruction helpful to you?

the refrigerator stop making ice and only the bottom part was cooling

first i order a defrost termostate i replace it but wasnt the problem then i
unpluged the evaporator fan motor and test it and was not working order
a new one and working like new.

Parts Used:

Evaporator Fan Motor

Duarte from SEDRO WOOLLEY, WA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers

1 of 3 people found this instruction helpful.

Was this instruction helpful to you?

light bilb went out

replaced it

Parts Used:

Light Bulb

Denise from Landover, MD
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 6 people found this instruction helpful.

Was this instruction helpful to you?

loud noise fan blade broke,off balance

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

Parts Used:

Evaporator Fan Blade

EDWIN from ELWOOD, IN
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

The new motor mount screw holes were not threaded.

I had to tap the screw holes with a 8/32 tap so that the screws would not bind.

Parts Used:

Condenser Fan Blade

Greg from henrico, VA
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Socket set

1 of 5 people found this instruction helpful.

Was this instruction helpful to you?

no heat when drying

Replaced thermo-fuse

Parts Used:

Door Rack Freezer

Glen from North Tonawanda, NY
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver

Was this instruction helpful to you?

both door handles broke at different times

It was a-b but they did not send any screws. So make sure you save your screws.... I was very very amazed how fast the shipping was. very very fast.

Parts Used:

Door Handle

Ernestyna from Clearwater, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

warm fridge, cold frosty freezer

remove food, then the shelf, then use a hot air gun to defrost and loosen the back panel, then remove the panel, then defrost the coil and thermostat area. using wire tools, replaced the defrost thermostat,and re-assembled freezwr and test

Parts Used:

Defrost Thermostat

Jim from AuSable Forks, NY
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers

Was this instruction helpful to you?

Broken door rack

We simply replaced the door rack. It was extremely easy with the quick delivery of the product!

Parts Used:

Door Rack

Melissa from Kansas City, MO
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Broken door handle

Very simple. Remove the old one, 3 screws, install the new one, same 3 screws. Took longer to find and order part than install it.

Parts Used:

Screw

Door Handle

Dennis from Columbia Falls, MT
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers, Wrench set

Was this instruction helpful to you?

Needed a replacement for a broken doo rack

Snapped right in place, no problems at all.

Parts Used:

Door Rack

Ron from Tiffin, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

the racks on my doors had snapped and I needed new ones

I just put them right on. Took about a minute to figure on the right way to put the racks on (push them down from the top, until they snap into place), and it was done in less than five minutes. I was worried that this wouldn't work - I couldn't find the exact item # to replace the racks that had been on there. But it turns out that they are pretty interchangeable - the sub racks that the website suggested worked perfectly for me.

Parts Used:

Door Rack