CFEA500ACE Admiral Range - Instructions

Ordered and received the terminal block. Installed it along with a new 220V power cord and the appropriate insulator . Ensured the terminals were tight with a nut driver. Reinstalled cover. Then, using the control panel, I did a function check on all the heating elements, clock, oven light, to satisfy all operational requirements. All checked good! And, I was relieved that the control panel had not been shorted out as the terminal block was due to a loose connection. Easy fix.

Called repairman, he never called back for a week. Gave up and found your website, ordered the part. You said it would take 3-5 business days. You lied, it was there the next day. Taking old element out starts with shutting off the juice. Remove trays, pans, etc. Unscrew two screws, pull out elements ends, unclip from wires, reverse the process with new one. You need a light to do this.

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires reverse the order to install the socet was easy but after i was done discovered that the base of the old bulb was stuck in the socet keeped it for future use

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new light bulb in was not the problem.

Removed frame to cabinet lag screws
Slid oven out of cabinet (required because wire harness could not be pulled through inside of oven)
Removed two screws holding attaching sensor inside oven
Uncoupled wire harness
Installed new sensor in reverse order

Unfortunately, neither the new bake element or sensor fixed the problem, so I just ordered the more expensive control board -- hope that does it.

Turned off the breaker to the stove. Removed the screws holding the old parts in and unplugged the element. After reshaping the element because it got damaged in shipping I plugged the wires to the new element, replaced the screws and turned the breaker back on. Tried the stove and it has worked fine since.

Removed old coil by unscrewing the element and unplugging it from the wires, adjusted the terminal slightly and plugged in the wire from the new element.

It was a very simple process and would have taken me less time if I wasn't so old and couldn't bend easily!

Removed 2 screws, should have tripped breaker first but learned the hard way, unplug wires, install new.

Control panel was responsive however oven would not heat up. I Replaced sensor with one of the adapters and oven is now working again.

Unplugged stove. Removed door. Unfastened 2 screws at rear of oven. Removed wires from bake element. Connected new bake element. Replaced screws and door. Plugged oven back in.

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires attached to the element, reattached to new element and replaced screws. This was very easy, I was glad I did not call the repairman.

Remove the bottom rack from the oven. Pull the heating element straight back and out of the oven. Inserted the replacement burner in the opposite manner. Part was delivered in a timely manner.

It would've been so much easier if replacement instructions were included. Replacement screws would've been nice also

I watched the video intructing the installation of the bake element. The one thing I would suggest is to remove the oven door as this allows someone with a shorter reach to do the repair.

Unscrewed two screws holding element in place and pulled off the electrical wires to the element.( be sure to remove power to the stove)Put wires on new element and installed screws back in. Done