62946975 Kenmore Range - Instructions

Just plugged them in and reset the door,.

Just great.

first I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires then I took new element and plug the wires in it pushed the element back in place and replaced the two screws

Replaced one of the four burner control switches on my Jennair cooktop. One of the tricks I use to prevent mistakes is putting the new switch along side the existing one and swap one connector at a time over to the new switch preventing any confusion and negating any need to mark the wires. This differs from your video assistant who disconnected all the wires at once.
gc.

Turned off the circuit breaker for the oven. Took the existing element out (really easy...a couple of screws is all) tested it with my volt meter and saw that it was bad. If you don't have a volt meter a local appliance repair shop may test it for you. Put the element back in so I could flip the breaker and use the stove top while waiting for the new element. New element came within three days. Flipped the breaker again, removed broken element and replaced it with new one. Flipped the breaker on and oven heated right up when preheated to 450 degrees :)

It was hard. I simply replaced the old one!! fIT PERFECTLY.
:-)

Turn off the power, unscrew the two screws holding the element. Without any tool, pull the wires off the connectors. and remove the bad element.
Connect the new element. push into place, and screw it in.
Maximum 15 minutes, and didn't get my hands dirty.

Removed two screws, unplugged the old unit, plugged in the new, screwed the new in. Job done. Would have been less than five minutes if I hadn't kept dropping the screws.

Husband got on partselect.com and read reviews, we ordered a long oven sensor kit. When it came in the mail, I took it out and look at it, decided I could probably switch the part.... and so I did. Easy Breezy ... and it worked well

2 screws to remove
disconnect 220 v power
use long nose pliers to transfer 5 female spade terminals
use nut driver to r@r shaft nut
replace panel with 2 screws
Turn on power and test!---OK!

Removed old grease filter,replaced with new grease filter. No tools needed.
I ordered the grease filter on Tuesday and it arrived at my door on Wed.
Best experience ever ordering a part, I will definitely use Part Select again and have already recommended it to friends.

see example. that's just how it went. easy. not really worth reporting.

very easy - not really a "repair" more of a face lift, although the grill was unusable.

Parts were perfect - Used it the same night.

I turned off the breaker for the oven. Then I unscrewed the 2 screws holding the element in and pulled the element out. I unhooked the wires from the element and put the new element in. Reconected the wires, pushe it back into place and replaced the 2 screws. Turned the breaker back on and it works GREAT! Way easy!!! ...even for a girl!

I remove fore screwsfrom the front panel. Then remove two screws to remove the switch and removed the wire plugs then put everything back together again.

I used a pair of plyers to remove both items and pushed new items in holes. Job complete