All Installation Instructions for Whirlpool Refrigerator 5WSC20CAYY00

No Repairs Required, Added One Bin-Cntlur

Slide into position.

Parts Used:

Philip from Pleasanton, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Switch didn't work

followed the video as instructed. Saved two repairman calls, one to find the problem, one to install. Net savings was about $130.00

Parts Used:

Refrigerator Door Switch

Don from Laramie, WY
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins

Was this instruction helpful to you?

Broke the arm off the food compartment rocker switch

After receiving the new part almost immediately,using two screw drivers, removed the broken switch from the plastic frame. Be careful not to scratch or otherwise tear the plastic...very pliable. Since the original switch was factory installed and the wires were packed in fiberglass insulation, the switch came out but the wires and clips were still in place and could not reach the new switch. It was necessary to pull them down with bent long nose pliers...used a lot of "pull" but the wires held up.Connected the switch, turned the power on and there was light! Reports from other users really took the uncertainty out of the task.

Parts Used:

Refrigerator Door Switch

David from St. Pete Beach, FL
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

Both light bulbs had been replaced, but lights did not turn on.

I tried to remove the old light switch using a putty knife and a hammer. It was hard to compress the plastic tabs to pull it back through the hole, but all of a sudden, the lights came on. I guess banging on the switch freed-up the contacts. The new switch is now a spare part in case I need it.

Parts Used:

Refrigerator Door Switch

Richard from Arlington, MA
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

broken fan blade

unplug refrigerator, take backing off with nut driver. Pull old blade off and put new blade on. Put backing back on and plug in.

Parts Used:

Fan Blade

David from Ceres, CA
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

Was this instruction helpful to you?

Broken rear support wheel

remove fiber grill cover, remove large bolt holding under frame ( with a 2X4 block, place under refrigerator on outside edge so frame can drop down.) remove pin from broken wheel, replace reversing proceedure. Note: when blocking refrigerator, care must be taken not to let block extend under entire frame. it only needs to be placed approx 3/4" under edge of refrigerator.

Parts Used: