Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 4KSRS27QAW00 > Parts

4KSRS27QAW00 KitchenAid Refrigerator - Parts

All parts for the KitchenAid Refrigerator 4KSRS27QAW00

Below is a list of all parts for the KitchenAid Refrigerator 4KSRS27QAW00. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the 4KSRS27QAW00
1-14 of 370
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$4.74

Door Cam - Black

The lower door cam is also known as the closing cam or door closer cam and can be found on your refrigerator or freezer door. The purpose of the lower door cam is to lift the door ...

$23.78

Bi-Metal Defrost Thermostat

If you have ice building up in your freezer, or if your freezer is getting too warm during the defrost cycle you may need to replace the bi-metal defrost thermostat. The function of the defrost bi-metal thermostat is to clip onto the evaporator and protect your evaporator from overheating during the defrost cycle. If your refrigerator does not defrost properly you can test both the thermostat and the heater to figure out which part is at fault. For this repair, you will need a Phillips screwdriver, a 1/4 inch nut driver, a flat blade screwdriver, a pair of wire strippers, a roll of electrical tape, and a few butt splice connectors.

$65.25

Icemaker Control Assembly

The icemaker control assembly is located in the freezer section of your refrigerator. It is what controls the icemaker. The control turns the timing cams and the ejector blades. It...

$63.28

Thermostat Assembly

This thermostat assembly is used in refrigerator units and freezers as a sensor. The thermostat senses the temperature increase in the evaporator during the cycle of defrosting and turns off when ice is melted. If you have any of the following symptoms, replacing your appliance could solve the problem: fridge does not start, is too warm, too cold, runs too long, or will not start. The tools needed for this repair project is a putty knife, Phillips and flat blade screw driver, 1/4 inch nut driver, and needle nose pliers. Remember to unplug refrigerator from power source as a safety precaution. Refer to the manual provided by the manufacturer for further installation instructions.

$2.96

Screw

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this sc...

$29.94

Ice Bin Auger Drum

This white ice bin auger drum comes with a washer.

$5.21

Icemaker Water Fill Tube Kit

The icemaker water fill tube provides water to the icemaker so it can produce ice and dispense water. If you notice that your ice maker is not making or dispensing ice, or is leaki...

$14.90

Door Closing Cam Kit

This door closing cam kit is intended for use with the bottom of refrigerator and freezer door hinges. The cam helps with the closing of the doors and to keep them slightly in position when opened.

$55.93

Ice Bucket

Bucket only. All other parts sold separately. This part holds the ice once it's released from the icemaker.

$16.51

Micro Switch

This switch is located inside the dispenser.

$6.15

End Cap Trim Piece

Sold individually.

$25.68

Shelf Support Stud

This is a 12 piece kit.

$12.75

Ice Dispenser Door Chute

*Please note, this door chute is no longer being manufactured with a heater.

$29.04

Fan Blade

Used with Evaporator Fan Motors.

All Parts for the 4KSRS27QAW00
1-14 of 370