3200 - Parts

CABLE, AUGER DRIVE

★★★★★

★★★★★

(1)

This item is available as an individual replacement part. The clutch cable is made of metal and plastic and helps with the auger assembly. If this item becomes stretched or broken it will need to be r... Add to cart

Kit, Rubber Blade Replacement

★★★★★

★★★★★

(1)

This is available as a set that contains four blades and two shoes. A socket set may be required to replace these parts if they become broken. They attach to the auger assembly and are made out of rub... Add to cart

Lawn Mower Grease Benalene (8 Oz) Add to cart

Washer, 5/16 This flat washer is an OEM part that is silver in color, made of metal, and its job in your equipment is to spread load and pressure under a bolt. It can have multiple uses depending on your equipment... Add to cart

BOLT, #10-24 x 1/2" Flat Head Square Neck, YZ Designed to fit inside the lock nut so both parts can be tightened, this Flat Head Carriage Bolt is not part of a kit or assembly and is sold individually. It is approximately 1/2 an inch long, made o... Add to cart

Lawn Mower Bushing This is a genuine manufacturer-approved part which is made for use with Murray and Snapper riding lawn mowers and garden tractors. It is one of the special bushings that are utilized on the equipment.... Add to cart

Spring-extension This OEM Extension Spring measures .62 x 6.12 inches. It is a silver, metal, individually sold, part. It can be installed with pliers and has been rated Easy to install by customers. (Note: Installati... Add to cart

Trimmer Ball Joint This authentic component is specially designed for MTD riding lawn mowers and garden tractors. It is supplied directly from the original equipment manufacturer. The ball joint is an important part of ... Add to cart

Cap-push The Push Cap is a black plastic cap which secures to the end of a shaft to prevent injury. It can be installed with a hammer and is rated as "Easy" to install. If the part appears damaged or worn down... Add to cart

Lawn Mower Flat Washer The metal flat washer is priced individually. It attaches to the cast iron axle along with the bolt and the bearing. A set of pliers, a screwdriver, and a wrench may be necessary during the installati... Add to cart

Bearing-flange The Hex Flange bearing, .630 inches I.D. is an OEM part. Black in color and made of metal, it is sold individually. It is installed using a wrench or socket and its installation has been rated as Easy... Add to cart

Deflector, Discharge

★★★★★

★★★★★

(2)

This part is an OEM sourced directly from the manufacturer for use in Snapper snowblowers. The discharge deflector attaches to the discharge chute extension. A socket set might be needed during the in...