1068254913 Kenmore Freezer - Instructions

Just like the video showed me.It still does not work. Have to turn it off and on to make it start up.I also replaced thermostat in freezer. Does not work.

Follow instructions from owners manual. top hinge first then move door upward and replace broken cam with new parts

It was so easy I could have done the video. Many thank you's for saving me $79.00 in house call fees.... cindi

After disconnecting the electricity. I followed the instructions as indicated in the "HOW TO" article on the website. I used a steel putty knife and pried the light switch out of its retaining hole. I worked the right side the most since this is the side with the retaining clip. After I removed the switch I transferred the two electrical outlets to the new switch and easily snapped it into place. Engaged the electric power and tested the switch.

disconnected el. power to fridge. pried out broken switch with small screwdriner and pulled out w/water pump pliers. installed new switch and pressed into opening.

I was quoted $212.00 by a service co. to make this repair. When I investigated online @ Part Select, they had all of the parts shown on schematics of each section of the refrigerator/freezer (side by side)with part numbers shown. It was easy to find the necessary parts.The cam kit came as a package for both doors and cost $12.00 plus shipping. Installation instructions were included.It took me an kour to make the repair. The hardest part was removing all the condiments from the shelves and remembering from which shelf they had to be returned. Net savings $200.00

Removed the door, installed the lower cam & re-installed the door. Diagram & parts list correct. An easy repair.

rem upper hinge on door on & lifted door off. installed kit provided & ressemble.

I removed the door (three screws on top). Flipped the door upside down, removed the cams, and replaced with the new ones and replaced the door. Now the door closes great. The only problem is that the door sort of "clunks" into place when I open or close it. I am not sure that I used the right cams. The drawing on the directions was not at all clear.

it was a simple repair once I located the part I had to replace . I really like your speedy delivery of the part I needed Thank you Pat Crotty

I removed the door and replaced the door cams and reinstalled the door

I watched the how-to video on your website first and it made the job so much easier. Just remove the upper hinge, lift the door off, and replace the cam bushings on the bottom hinge. Put it back together in reverse order and your done! Thanks for having such an informative website! It saved me from buying a new appliance.

I pried the old one out with a screw driver and pushed the new one in. I expected instructions in the box it came in but there were none.

Part # had been replaced with another timer. Original timer had 2 wires coming out of it. Replacement only had 1 wire. Instructions showed 2 options for where to place the wire. I chose option 2 and I guess I was right. Installation took less than 15 minutes and refridge is back to normal. (Quiet)

Removed door,took out old part@replaced with new