Husqvarna Trimmer Seals and Gaskets
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Husqvarna Trimmer Seals and Gaskets
Your Price
$6.40
In Stock
Husqvarna Trimmer O-ring
PartSelect Number PS9287967
Manufacturer Part Number 537184901
This O-ring is a genuine OEM replacement part designed for use in a variety of power tools. It is a rubber seal used to prevent pressure loss, as well as oil, fuel, and air leakage from the fuel hose. It can be found on either end of the hose. You will need to replace this ring if it has lost elasticity, or if it is cracked or deformed. The O-ring can fail due to age, exposure to heat and chemicals, pressure buildup, or poor installation. A faulty ring will result in leakages, pressure loss, and decreased equipment performance. Carefully pry the old O-ring off the hose. Remove any dirt or debris in the area and lubricate the new ring before placing it in position. Apply light pressure to the ring until it is secure and sitting snugly. Note that your equipment may have several O-rings, therefore, inspect all of them as each ring is sold individually.
Your Price
$30.58
In Stock
Husqvarna Trimmer Walbro Gasket/diaphragm Kit
PartSelect Number PS9285128
Manufacturer Part Number 530069844
This is an authentic OEM replacement kit for use with lawn and garden equipment. Each kit includes the carburetor, cylinder, crankcase, and muffler gaskets. The carburetor gasket seals the area between the carburetor and engine block to prevent the entry of contaminants into the carburetor. The crankcase gasket prevents oil from leaking out of the crankcase. The cylinder and muffler gaskets prevent the combustion and exhaust gases from escaping. If you are experiencing common problems such as leaking, loss of compression, and poor engine performance this indicates that your gaskets may be worn down or damaged and need replacement. Carefully remove the old gaskets and thoroughly clean the mating surfaces where the new gaskets will be installed to ensure a good seal. Install the new gaskets and ensure that they fit properly.
Your Price
$6.40
In Stock
Husqvarna Trimmer Gasket
PartSelect Number PS8990133
Manufacturer Part Number 503497101
This Carburetor Gasket provides a tight seal between the carburetor and insulator. If broken, the engine will run lean due to excess air causing performance issues, and the part should be replaced. If the carburetor has to be taken off for any reason, the gasket should be replaced, as it is one-time use. Installation requires a screw driver and pliers, and is rated as "Easy".
Installation Instructions
Richard from CHINA GROVE, NC
Weed eater flooded constantly.
Very simple repair...took the old carburetor off and installed the new one. After replacement, the weed eater fired up after the second pull. Cover, removed 4 bolts. Carburetor, three bolts. Removed two hoses, choke handle and installed. Order gasket...never hurts to replace gaskets. One other thing, most important...use premix fuel!!! I use it in all gas powered equipment now. Cleaner and does not gum up filters and carburetor.
Read more...
Your Price
$18.34
In Stock
Husqvarna Trimmer Kit, Carb. Gasket
PartSelect Number PS9030255
Manufacturer Part Number 545008086
This is an authentic OEM sourced part that is intended to be used with trimmers and brushcutters from Husqvarna and Jonsered. The gaskets are used to mount the carburetor to the engine's intake. It is recommended to replace the gaskets when servicing the carburetor to ensure proper seals when the parts are reassembled.
Your Price
$5.50
In Stock
Husqvarna Trimmer Kit Gasket
PartSelect Number PS16365371
Manufacturer Part Number 545008044
This gasket kit is designed for use in gas trimmers. The kit is OEM verified for rebuilding and repairing the engine. It includes a carburetor gasket used to prevent fuel and air leakage between the carburetor and engine; a cylinder gasket, to seal the area between the cylinder and the engine block; a crankcase gasket to prevent oil leaks and maintain proper pressure; an intake manifold gasket to seal the area between the intake manifold and the engine; an exhaust gasket, to prevent exhaust leaks between the exhaust port and the muffler; a fuel tank gasket to prevent fuel leaks; and an oil pump gasket to maintain adequate lubrication and prevent leaks. If these gaskets are no longer functioning, you will notice difficulties starting your trimmer, lower power output, excessive fuel consumption, and leakages. This kit allows you to easily replace the gaskets at the same time to restore your engine back to working order.
Your Price
$6.40
In Stock
Husqvarna Trimmer Gasket
PartSelect Number PS11822760
Manufacturer Part Number 525548501
This is a genuine replacement part that has been sourced from the original manufacturer to be used with trimmers from Husqvarna and Jonsered. The gasket is used to seal the connection between the carburetor and the mounting bracket. This item is sold as an individual replacement part.
Your Price
$6.40
On Order
Husqvarna Trimmer O-ring
PartSelect Number PS9016925
Manufacturer Part Number 532197480
This is an authentic manufacturer-approved part which is specially designed for use with lawn and garden equipment. It helps to provide a tight seal between connected components. Unfortunately, over time it may wear out and it may begin to crack eventually requiring a replacement. Keep in mind this high-quality item is made of durable rubber and is sold individually. Please make sure to check the diagrams of your model for the correct location and application of this hardware.
Your Price
$6.40
In Stock
Husqvarna Trimmer Chainsaw Washer
PartSelect Number PS8990950
Manufacturer Part Number 501278201
It is a genuine manufacturer-sourced component which is specially produced for use with Husqvarna and Poulan lawn and garden equipment. This replacement gasket is used to provide an air-tight seal for the fuel cap to prevent any leaks. Over time the material may begin to deteriorate and crack eventually requiring replacement. It is a high-quality component which is made of durable rubber material and it is sold individually.
Your Price
$30.58
In Stock
Husqvarna Trimmer Chainsaw Gasket Foam Kit
PartSelect Number PS9030153
Manufacturer Part Number 545008084
This gasket foam kit is an OEM direct from Husqvarna. Made for use with many lawn trimmer devices, the kit provides sealing items for the motor. The gasket foam kit includes seals, gaskets and other items for the repair. A screwdriver, pliers and an adjustable wrench are needed for the replacement.
No Longer Available
Husqvarna Trimmer Gasket Set
PartSelect Number PS12602552
Manufacturer Part Number 530071750
This is a Manufacturer Approved replacement kit used on a variety of Gas Trimmers/Pruners. This gasket set includes the major gaskets to replace when rebuilding the engine. Its purpose is to make an air tight seal so that no air/oil leakage occurs. Over time gaskets tend to deteriorate and will need to be replaced. Gaskets in this kit are made out of Composite Material and O-Rings are made out of Rubber.
Related Husqvarna Trimmer Parts
- Husqvarna Trimmer Bearings
- Husqvarna Trimmer Blades
- Husqvarna Trimmer Brackets and Flanges
- Husqvarna Trimmer Caps and Lids
- Husqvarna Trimmer Carburetors
- Husqvarna Trimmer Control Cables
- Husqvarna Trimmer Engines
- Husqvarna Trimmer Exhausts
- Husqvarna Trimmer Filters
- Husqvarna Trimmer Gears
- Husqvarna Trimmer Handles
- Husqvarna Trimmer Hardware
- Husqvarna Trimmer Hoses and Tubes
- Husqvarna Trimmer Ignitions
- Husqvarna Trimmer Knobs
- Husqvarna Trimmer Latches
- Husqvarna Trimmer Manuals and Literatures
- Husqvarna Trimmer Pulleys
- Husqvarna Trimmer Spark Plugs
- Husqvarna Trimmer Springs and Shock Absorbers
- Husqvarna Trimmer Starters
- Husqvarna Trimmer Switches
- Husqvarna Trimmer Tanks and Containers
- Husqvarna Trimmer Transmissions and Clutches
- Husqvarna Trimmer Wheels and Rollers
- Husqvarna Trimmer Wire Plugs and Connectors