Husqvarna Lawn Tractor Filters

Videos!

Your Price

$9.62

Husqvarna Lawn Tractor Engine Fuel Filter

★★★★★

4 Reviews

PartSelect Number PS9285148

Manufacturer Part Number 530095646

This Genuine OEM fuel filter is designed to maintain the performance and longevity of your equipment by preventing dirt and debris from entering the carburetor. Located inside the fuel tank, this essential component ensures clean fuel delivery, protecting the engine from potential damage caused by contaminants. Sold individually, the filter is built to meet original equipment standards for fit and function. Over time, the filter may become clogged, restricting fuel flow and making engine starts more difficult. For optimal performance, it should be replaced—not cleaned—at the first sign of blockage or wear.

Fixes these symptoms

Engine stops after a few seconds or minutes
Will Not Start
See more...

Installation Instructions

Mark from LYNDONVILLE, NY

Deterioration of fuel line system

Removed the top cover (T25 torx), and side cover (T25 torx) with recoil starter. Drained all fuel, and removed all pieces of fuel old fuel line and the weighted filter from inside the tank by shaking out and the (long forceps). A spot headlamp makes it easier to see inside the tank for much of the procedure. Remove the foam filter to find the two 8mm nuts and remove the air filter housing and carburetor (nut driver, 8mm socket) the choke lever slides out of its slot with some wiggling and moving the carb back off the mounting studs. Leave the throttle cable attached to the filter housing and move both assemblies out of the way to access the top wall of the fuel tank. There is a cover over the carb adjust screws that wiggles out also. The fuel line and purge line both pass through the wall of the tank and need to be pulled out with some effort (long curved forceps) from inside the tank through the fuel fill port. They are a tight fit. Pay attention to the lines size and location. Large line is in the position away from the recoil starter with the little plastic fitting hanging near the top of the tank. The smaller line is closest to the recoil starter. Both new lines will need to pass through the tank wall (this is the most difficult part). To facilitate the initial entry through the wall of the tank, cut a tapered end on your new lines. Use a very slippery lube to coat the end of the line and push it into the tank as far as you can from the top (forceps or soft grip pliers) help. Look inside the tank and pull the lines through fully out of the tank fill (long curved forceps and head spot light). Don't pull all the way through the fuel fill, just enough to install the new fuel line fitting in the return purge line and the new weighted filter on the fuel line and pull the lines back inside the tank. The return line with fitting close to the top of the tank and the filter hanging so it lays at the bottom of the tank, and able to swing around so it keeps contact with fuel at all times. Remove the old purge/primer bulb two screws (Phillips). The short stem is suction, long stem is pressure. Don't mix them up and connect lines backwards, don't ask me how I know! Lol! If you have such a saw like mine, that has no fuel lines intact, it is difficult to vision the line routes. There are helpful schematics on the internet. Just remember that the purge bulb long fuel stem sends pressure back to the tank through the return line (larger line in the tank with the line fitting away from the recoil). That line can now be cut to length and pushed on the bulb long stem. The suction side of the bulb short stem, connects to the purge line on the side of the carburetor (short line). You need to cut that line to the same length as the old one. It has to curve twice to get to the suction side of the purge bulb without kinking. The only other line left is the fuel line with the filter attached hanging inside the tank. Be sure you have the filter able to lay on the floor of the tank and move around. That line connects to the carburetor opposit side from the purge bulb. Dont cut that one until the carb is installed for proper length. The fuel routes from that filtered line into the carb, then out of the carb to the purge bulb suction side, then out to the return line in the tank with the fitting end. That fitting installed into the line serves only to keep the line from pulling back out of the tank, nothing attaches to it. Make sure all lines are clear of the mounting area of the carb, and throttle function. Pass the bulb lines through the slot in the side of the case being sure the lines don't kink. Secure the bulb with the two phillips screws. Position the carb on the studs and slide the choke lever into its place in the case as you go. Place the filter housing on the studs and push the carb and housing down watching the fuel lines for any kinks, especially where the throttle cable is in close proximity to the short carb purge line. Check the throttle function for interferance, and Install the two 8mm nuts. Now route the fuel line around the throttle mechanism out of the way, hold it to the barb on the side of the carb and cut it to length and install. Put some fuel mix in the tank (dont fill it) to test. Press the primer bulb, tilting the saw with fill cap removed, and see if anything leaks, also watch fuel flow back to the tank inside as you press the bulb. You should see fuel and air bubbles from the purge line. When all air bubbles are gone the system is purged. Install the new foam filter in the housing and then the top and side cases. I did not reinstall the cover of the carb adjust needle screws so I could adjust the fuel/ air mixture to run at peak performance. Hope this helps! The kit that I got was perfect and there are some useful instructions included. Thank you! Respectfully Mark Read more...

Your Price

$12.98

Husqvarna Lawn Tractor Fuel Filter

PartSelect Number PS11835770

Manufacturer Part Number 49019-0027

This OEM Fuel Filter is a white, individually sold, plastic part, which measures 3 x 1.25 inches. It can be installed using pliers and is rated as Easy to install by customers (Tip: Make sure the fuel clip is secure when installing). This part is attached along the fuel line, between the fuel tank and carburator, and is used to filter contaminents out of the fuel. If broken fuel will leak, and it will smell. If clogged, there will be no fuel flowing out of it. If broken or clogged, it should be replaced. It should also be replaced during regular maintenance. Check your owners manual or model number to ensure you are selecting the right part.

Your Price

$19.76

Husqvarna Lawn Tractor Filter, A/c Cartridge

PartSelect Number PS18580335

Manufacturer Part Number 84012892

Your Price

$26.21

Husqvarna Lawn Tractor Filter-air Cleaner Cartridge

PartSelect Number PS9137470

Manufacturer Part Number 793569

This is a specially designed air cleaner filter cartridge for use with Briggs and Stratton engines. These engines are commonly installed on lawn and garden equipment. The purpose of an air cleaner is to filter out dust and debris from entering and damaging the engine. This part consists of a paper pleated filter with two plastic covers and a metal frame. It is advised to replace pre-cleaner filter when replacing cartrigdge. Please note it is sold separately. Replacing this filter is an easy task which requires no tools. • Unscrew cover knob • Remove air filter cover • Remove cartridge and pre-cleaner • Clean any dust from the filter holder/base • Install new filter • Reassemble and test the engine

Your Price

$32.06

Husqvarna Lawn Tractor Element: Air Filter

PartSelect Number PS9942257

Manufacturer Part Number 3208309-S

This is an original replacement part manufactured for use with Kohler small engines. The air filter element traps dust and debris to prevent contamination of intake air. Replacing air filters is part of normal engine maintenance, please note the air filter is sold individually.

Your Price

$6.40

Husqvarna Lawn Tractor Filter Fuel Mega Pack

PartSelect Number PS17016257

Manufacturer Part Number 394358B

This Fuel Filter is a white plastic part attached within the fuel delivery system between the fuel tank and carburetor. Installation is rated as "Easy" and requires a set of pliers and a screwdriver. If broken, there may be a leak or blockage and the part should be replaced. The part may also need to be replaced according to manufacturer's specifications, and is a manufacturer-approved part. Refer to your make, model and diagrams to ensure this part is correct.

Your Price

$20.08

Husqvarna Lawn Tractor Filter-a/c Cartridge

PartSelect Number PS8982418

Manufacturer Part Number 499486S

This is an authentic manufacturer approved replacement part designed for use with lawn and garden equipment engines. Its purpose is to filter out dust and debris from contaminating the carburetor. This filter is made out of paper and plastic. It is sold individually. To replace this filter no tools are needed. • Remove the air cleaner cover • Replace the air filter • Secure the cover back

Your Price

$6.40

Husqvarna Lawn Tractor Filter-pre Cleaner

PartSelect Number PS9138059

Manufacturer Part Number 793685

This is an authentic OEM sourced replacement air filter element which is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. The purpose of this part is to ensure that the air supplied to the unit is free of dust and other harmful contaminants. Unfortunately, over time it may get dirty and clogged eventually requiring a replacement. This high-quality pre-cleaner filter is sold individually, keep in mind the main filter element is sold separately.

Your Price

$44.51

Husqvarna Lawn Tractor Screen

PartSelect Number PS8865096

Manufacturer Part Number 14037-7008-9H

It is an authentic item that is supplied by original equipment manufacturer for Kawasaki engines. This replacement screen is secured to the fan housing helping to protect the fan from dirt and debris. It is made with durable high quality plastic and it is sold individually, please note the hardware to secure it is all sold separately.

Your Price

$24.96

Husqvarna Lawn Tractor Filter-oil Bulk

PartSelect Number PS18635301

Manufacturer Part Number 49065-0736BK

Shop by Department

Top Appliance Brands

Top Lawn Equipment Brands

Popular Husqvarna Lawn Tractor Filters

Related Husqvarna Lawn Tractor Parts

Shop by Department

Top Appliance Brands

Top Lawn Equipment Brands

Sample Model Number Tags

EasyApplianceParts is Now PartSelect!

Husqvarna Lawn Tractor Filters

Find Your Part

Popular Husqvarna Lawn Tractor Filters

Related Husqvarna Lawn Tractor Parts