Water Pump Springs and Shock Absorbers

Water Pump Trimmer Spark Plug Coil This spark plug wire, also known as a spark plug coil or spark plug cap coil, is compatible with various makes and models of hand-held outdoor power equipment and is sold individually. This wire is installed within the spark plug boot and attaches to the spark plug for the ignition of your equipment. The spark plug wire is often exposed to extreme heat and excessive vibrations, so through normal wear and tear, it will likely break down. If your equipment is having difficulty starting or has general performance issues, the wire may be the reason why. To replace this wire, make sure your equipment is off before removing the wire and boot from the spark plug. Remove the boot from the wire and install the new wire within the boot before re-installing the boot back to the spark plug.

Water Pump Spring This OEM spring, also known as a recoil or rewind spring, is housed in a container and is used to retract the starter rope on various lawn equipment models. Over time and through use, the spring will eventually lose its tension, and will break. If your starter rope has no resistance when pulling it, the starter spring is likely broken. Measuring at approx. 3-inches by 3-inches, this spring is suitable for use with a variety of lawn equipment models and is sold individually.

Water Pump Rod Spring This rod spring is an original part that is designed for use with Subaru / Robin engines commonly installed on a variety of lawn and garden equipment. The spring applies tension on the governor rod allowing it to retract. Over time it may wear out and lose tension eventually requiring a replacement. It is made of high-quality metal and is sold as an individual component. Check the diagrams for your model for the exact location and the correct installation of this rod spring. It is a simple repair that should only require pliers to remove the old part and attach the new one.

Water Pump Return Spring This part is an authentic manufacturer-sourced replacement part which is specially designed for trimmers, brushcutters and blowers. This part is sold individually and made of metal. The return spring helps return the starter pawl back to the regular position after you are done starting the engine with the recoil starter.

Water Pump Throttle Return Spring This compression spring is sourced directly from the original equipment manufacturer for use with Honda engines commonly installed on a variety of lawn and garden equipment. It is an important component that allows the throttle to retract. Over time it may wear out and lose tension eventually requiring a replacement. To ensure the correct installation of this hardware, check the diagrams of your specific model. Keep in mind this high-quality spring is made of durable metal and is sold as an individual component. You may need a screwdriver and pliers to perform this repair.

Water Pump Spring- Valve This is an authentic replacement part sourced directly from the manufacturer. The valve spring is commonly found in small engines from Honda. This part is made of metal, and is used to provide tension between the inlet/exhaust valves and the rocker arms. This item is provided as an individual replacement part.

Water Pump Governor Spring

Water Pump Seat- Valve Spring This item is available as an individual replacement part. The valve spring seat goes between the valve spring and the valve. A set of pliers might be required during the replacement of this item. It is made of metal and will require replacing if it breaks. This is an authentic OEM part from Honda and Lawn Boy for use in engines.

Water Pump Spring- Throttle Return It is a genuine item which is supplied directly from the original equipment manufacturer for use with Honda engines commonly installed on lawn and garden equipment. This is an identical replacement for a missing or faulty throttle return spring that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality spring is made of durable metal is sold individually.

Water Pump Spring- Cable Return This is a genuine manufacturer-sourced part which is specially designed for use with Honda engines commonly installed on lawn and garden equipment. It is an identical replacement for a missing or faulty spring that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.