Table Saw Hoses and Tubes

Table Saw Rubber Nozzle Assembly This is a manufacturer sourced replacement part used on some Ridgid tile saws. This part is made out of rubber. It helps to deliver water to the cutting wheel. It maximizes water efficiency and provides easy maintenance. Note that when installing nozzle, the hole must be pointing towards the saw. One (1) rubber nozzle is included per order.

Table Saw Spacer Tube This genuine OEM item is specially designed for Ridgid table saws. It is a special component which provides spacing between the bevel wheel and the handwheel. If the part is damaged or is missing, this will provide an identical replacement for the original part that was installed on a new unit. Note, this high-quality spacer tube is made of durable material and is sold as an individual component. Replacing it is a simple task that does not require any special tools. Refer to the appropriate diagram for your model to ensure the correct repair procedure.

Table Saw Blast Pipe This is a genuine Delta replacement part used on contractor saws. The plastic blast pipe connects to the dust chute assembly to allow saw dust to exit the saw while in use. A small phillips head screw driver may be needed to remove the blast pipe from the dust chute. The hardware required to install the blast pipe is not included, and the blast pipe is sold individually.

Table Saw Dust Collection Tube

Table Saw Suction Tube

Table Saw Right Rear Extension Tube

Table Saw Front Guide Tube 52-inch

Table Saw Tube Base

Table Saw Hose

Table Saw Right Extension Tube