Simplicity Lawn Tractor Seals and Gaskets

Your Price

$5.14

Gasket--Exhaust

PartSelect Number PS9294808

Manufacturer Part Number 692236

Installation Instructions

FRANK from EASTANOLLEE, GA

Screw can out of the carburator throttle baffel and stuck in the exhaust valve

No compression. Removed the cylinder head. freed the screw, checked the valve to see if it still sealed. Turned the head over with the valves in it, install a spark plug, fill the head dome with gas and see if any leeks out over a 2 hr period. If not you are good to go. Reinstalled every thing with new gaskets and a new carburetor screw. Set the valves to spec. Complete the rebuild and there you have it. Rebuild the carburetor while you have it apart. This motor runs great !!! Read more...

Your Price

$5.61

Gasket, Foam

PartSelect Number PS9902311

Manufacturer Part Number 1707335SM

Your Price

$10.76

Seal

PartSelect Number PS8916558

Manufacturer Part Number 2118118SM

The Oil Seal is used to seal the gear case where the axle extends from the case, around the axle shaft. It's rated as "Easy" to install, and will require a wrench set and seal puller. When installing, use something big enough to make contact with the entire seal, such as a PVC pipe, and tap gently into place. If broken, you will see oil leaking, and the part must be replaced. This gray, rubber part is sold individually. Refer to your make, model and diagrams to ensure this is the correct part for you.

Your Price

$5.14

Gasket-Exhaust

PartSelect Number PS9063564

Manufacturer Part Number 690970

Installation Instructions

george from HALLWOOD, VA

valve problem causing pushrod damage

pinged valve guide reinstalled head with new gasket inserted rods adjusted valve 15 min. later mowing lawn first time doin such repair note used magnet to pull old rod inside engine to drain left in rotated engine maling sure no parts broken started up and away i went c how long it lasts mower had over6500 hrs.. on it Read more...