Shindaiwa Hedge Trimmer Bearings

Shindaiwa Hedge Trimmer Ball Bearing 6201 This single-row, deep-groove ball bearing is sized at 12x32x10mm and is made of durable metal. It is used to reduce friction and vibrations when it is in between two parts that are rotating or moving against each other. This bearing can handle forces that are applied to it up-and-down and sideways, also known as radial and axial loads. It is easy to install and can handle high rotational speeds without causing too much vibration or making much noise. Over time, this ball bearing wears out from heat and pressure and starts to fail. If the engine of your machine has been run without oil in the gas tank, this ball bearing can seize. In these situations, you will need to replace the ball bearings. Otherwise, you will notice that your machine overheats, works harder because of the increased friction it is handling, and produces excessive vibration and noise. To extract a ball bearing from your machine, you will need to insert a flat-head screwdriver through the bearing opening and against the seal. Then, tap the seal out with a mallet. Afterwards, slot a socket through the diameter of the bearing, and tap the entire bearing out of its place by again using a mallet. This authentic OEM part is sold individually, so be sure to refer to your user manual to verify how many bearings your machine needs and where they are in it.

Shindaiwa Hedge Trimmer Needle Bearing

Shindaiwa Hedge Trimmer Bearing, Ball - 6001 This authentic replacement ball bearing is supplied by the original equipment manufacturer for use with Shindaiwa and Echo handheld tools. Ball bearings are used to reduce friction between rotating parts, over time due to heat, pressure and vibration the components may wear out and begin to fail eventually requiring a replacement. For correct location and use of the part, make sure to check appropriate diagrams of your model. This high-quality bearing allows is made of durable metal and it is sold individually.

Shindaiwa Hedge Trimmer Trimmer Bearing This silver metal Ball Bearing is manufacturer certified, and used to reduce the friction between parts, and comes individually sold. If broken or worn down, you will hear a grinding, growling, stretching, or rumbling sound, and the part should be replaced. Installing this new part requires a bearing puller. Refer to your make, model and diagram to check if this is the right part.

Shindaiwa Hedge Trimmer Bearing, Ball 6000zz This is an original replacement part sourced directly from the manufacturer. The ball bearing is commonly found in yard tools from Shindaiwa, such as trimmers, edgers, and chainsaws. This part is made of metal, and is generally used to allow components to spin freely. It may be found in various locations in the machine, depending on model. Please be aware that there are different ball bearings used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You may require an Allen wrench or screwdriver when replacing this item. This product is sold as an individual replacement part.

Shindaiwa Hedge Trimmer Bushing

Shindaiwa Hedge Trimmer Bearing-ball 6001 This authentic replacement part is designed for use with Echo and Shindaiwa equipment. Ball bearings are used to reduce friction between rotating parts. The rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Over time components tend to wear out and may begin to fail eventually requiring a replacement. Please note this high-quality metal bearing is sold individually.

Shindaiwa Hedge Trimmer Bearing, Needle - 8

Shindaiwa Hedge Trimmer Bearing, Ball 628zz

Shindaiwa Hedge Trimmer Bearing-needle