Sander Seals and Gaskets

Sander O-ring (-008) This o-ring is an authentic manufacturer sourced replacement part, it is not an aftermarket imitation. It is specially made for Chicago Pneumatic air hammers and sanders. It helps to provide an air tight seal between connected parts. Please make sure to check appropriate diagrams for correct location and use of this item. It is made from durable rubber and it is sold individually.

Sander Piston Seal Ring

Sander Seal This is a manufacturer sourced replacement seal. It is specially produced for use with Dynabrade sanders. This is one of the seals for the tip valve/inlet bushing. Over time seals tend to shrink and crack allowing for air leaks. At that time it should be replaced to maintain top performance. It is made out of rubber material and it is sold individually. Replacing this item you would need a wrench to replace this item.

Sander O-ring This genuine Dynabrade replacement part is used in various power sander models. An O-ring is made to act as a flexible part connecting solid pieces, sealing and retaining pressure inside. Assorted styles of O-ring are often used in more than one spot in a machine, so ensure that the right one is being used for the right place. This item is sold individually.

Sander Seal

Sander Backhead Gasket

Sander O-ring This replacement o-ring is an original Dynabrade part that is specially produced for use with sanders, drills and grinders. It is an authentic OEM item that has multiple uses depending on your equipment, please make sure to check appropriate diagrams for correct location and use of this o-ring. Note one durable rubber o-ring is included per order.

Sander V-seal This is an authentic Dynabrade replacement part manufactured for use with pneumatic sanders. Seals on pneumatic tools can wear out over time from compression between part assemblies, or from weathering caused by exposure to chemicals or water. This seal is commonly used between the balancer shaft and lower bearing, please see model diagram for associative parts.

Sander Seal

Sander Exhaust Gasket This is an authentic Dynabrade replacement part manufactured for use with pneumatic sanders. The gasket is used to form a seal between the housing and the handle housing assembly. This gasket is sold as an individual replacement part, please see model diagram for associative parts.