Ryobi Pressure Washer Hoses and Tubes

Ryobi Pressure Washer High Pressure Hose

★★★★★

★★★★★

1 Review

This is a genuine Ryobi replacement high pressure hose that is supplied directly from original equipment manufacturer. It is specially designed for use with pressure washers. This high pressure hose is made out of rubber/plastic material. It is 25 ft long and it is sold individually. This hose can be used on pumps that produce up to 1700 PSI.

Ryobi Pressure Washer Outlet Tube This OEM outlet tube, also known as a hose connector, allows pressurized water to flow from the pump of your pressure washer to the nozzle. Connecting the hose to the handle assembly and the spray wand, it is where the water exits from your machine so you can direct the stream towards a desired surface. You can tell if an outlet tube is broken when it has visible cracks or holes and when water leaks or sprays from the connection points or along the tube. A damaged or blocked tube can result in a loss of pressure and potentially premature wear or machine failure. To remove the outlet tube, use a wrench set to unscrew it from the pump. Please note that this replacement part is sold separately from the pump assembly.

Ryobi Pressure Washer Water Hose (25 ft., 3000 psi) This water hose is for pressure washers. Water hose carries water from the pump to the spray wand. Wear work gloves to protect your hands when installing this part.

Ryobi Pressure Washer Chemical Siphon Tube It is a genuine replacement part that is supplied by original equipment manufacturer for use with Homelite, Ridgid and Ryobi pressure washers. This siphon tube is used to deliver the chemical solution from the tank to the pump. Over time the tube may develop cracks allowing for leaks, if this happens this part can easily be replaced. It is made of durable flexible rubber material and it is sold individually.

Ryobi Pressure Washer Nozzle This genuine OEM quick connect nozzle is guaranteed to fit the Ryobi pressure washers listed below. This yellow chiseling nozzle has a standard fifteen (15) degree spray width. This water-only tip is recommended for heavy duty pressure washing duties, such as cleaning stubborn stains and grime from hard surfaces. It is one step less powerful than the red zero degree tip (the most powerful quick change nozzle). Since it is such a commonly used nozzle, a backup could come in handy. Sold individually.

Ryobi Pressure Washer Inlet Connector

Ryobi Pressure Washer Inlet Tube This is an authentic OEM part for pressure washers made by Homelite, Ryobi, and Husky. The inlet tube fits onto the pump and is made out of metal. When replacing this part a socket set may be needed. It is available as an individual replacement part, but also includes the metal bolt and the rubber o-ring.

Ryobi Pressure Washer Soap Nozzle This is an authentic OEM part designed to be used on the Ryobi pressure washers listed below. This very low pressure nozzle is designed to draw soap/chemical mixture from the detergent tank, and spray it onto surfaces for cleaning. It is usually called a soap nozzle but can also known as a chemical injector tip. Includes one (1) nozzle.

Ryobi Pressure Washer High Pressure Hose

Ryobi Pressure Washer Outlet Tube Assembly This is a genuine Ryobi replacement part. The outlet tube assembly is designed by the manufacturer for use in pressure washers. This part is made of metal and comes with a pre-installed plastic O-ring. It is used to connect the pump assembly with the hose. You may require pliers or a wrench when replacing this item. This part is sold individually.