Poulan Leaf Blower / Vacuum Carburetors

Poulan Leaf Blower / Vacuum Purge Bulb This primer bulb, also known as a purge bulb, is used to push more fuel from the fuel tank into the carburetor of your small engine equipment, to help the engine start easier. Over time and through extended use and exposure to gas and oil, the bulb of the primer will eventually lose its elasticity and crack or break. This bulb is made of plastic and can be replaced by accessing the ignition system. Disconnect the fuel lines and pop out the bulb with a set of pliers, and once you pop in the new bulb, you just reconnect the fuel lines. This bulb is compatible with a variety of makes and models of small engine equipment and is sold as an individual part.

Poulan Leaf Blower / Vacuum Carburetor Kit This is an Authentic OEM replacement part used on Gas-Powered Handheld Gas Blowers. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. If the engine won\'t start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. Pull the starter rope. If the engine starts and then quickly dies, the carburetor is likely the problem. This Assembly includes a Metal Body Carburetor with a Plastic Throttle Lever and Two (2) Carburetor Gaskets.

Poulan Leaf Blower / Vacuum Walbro Gasket/diaphragm Kit

★★★★★

★★★★★

1 Review

This is an authentic OEM replacement kit for use with lawn and garden equipment. Each kit includes the carburetor, cylinder, crankcase, and muffler gaskets. The carburetor gasket seals the area between the carburetor and engine block to prevent the entry of contaminants into the carburetor. The crankcase gasket prevents oil from leaking out of the crankcase. The cylinder and muffler gaskets prevent the combustion and exhaust gases from escaping. If you are experiencing common problems such as leaking, loss of compression, and poor engine performance this indicates that your gaskets may be worn down or damaged and need replacement. Carefully remove the old gaskets and thoroughly clean the mating surfaces where the new gaskets will be installed to ensure a good seal. Install the new gaskets and ensure that they fit properly.

Poulan Leaf Blower / Vacuum Lever Choke C1u-w43

★★★★★

★★★★★

1 Review

This choke lever is an OEM replacement part intended for use in blowers. The choke lever acts as a control mechanism that regulates the air-fuel mixture during the combustion process. By adjusting the choke lever, you can either restrict or increase the amount of air flowing into the carburetor. When the choke lever is engaged, it restricts the airflow, which enriches the fuel mixture for easier starting in cold conditions. Once the engine is running smoothly, the lever can be disengaged to restore the normal air-fuel mixture levels. If the choke lever cannot engage, you will have difficulties starting the blower and notice reduced performance. Additionally, if the lever fails while it is in the closed position, the engine may become flooded, causing excessive fuel consumption, smoke, and stalling. You can find the choke lever near the carburetor. Carefully pull off the faulty lever from the equipment and snap the new one into place.

Poulan Leaf Blower / Vacuum Kit Carburetor C1u-w43 This genuine replacement part is designed for use with Poulan gas blower. It is sourced from original equipment manufacturer and it is sold individually. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. If the engine won't start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. Pull the starter rope. If the engine starts and then quickly dies, the carburetor is likely the problem. To complete this repair you would need a screwdriver.

Poulan Leaf Blower / Vacuum Carburetor Repair Kit This is a genuine OEM sourced rebuild kit is designed for gas trimmers/blowers. This kit contains all the necessary parts to rebuild your carburetor. It includes: primer bulb, the float, needle, gaskets, seals needed to repair or refurbish a carburetor. Replacing these items you would need a screwdriver and pliers.

Poulan Leaf Blower / Vacuum Trimmer Carburetor Boot This carburetor boot fits between the cylinder and the carburetor plate providing an air-tight seal. Over time due to heat and regular wear it may deteriorate and crack eventually requiring replacement to maintain optimum performance. It is a genuine replacement part that is supplied directly from original equipment manufacturer for use with Poulan and Husqvarna lead blowers and trimmers. Please note this high quality rubber carburetor boot is sold individually.

Poulan Leaf Blower / Vacuum Carburetor Plate This is a genuine Husqvarna and Jonsered replacement part for use in blowers. The carburetor plate goes between the gasket and the carburetor boot. A screwdriver and a nutdriver may be needed during the replacement of this part. It is made out of plastic and will need to be replaced if it breaks. This item is sold individually.

Poulan Leaf Blower / Vacuum Adapter This carburetor adapter connects the carburetor to the engine block in your lawn equipment. It ensures proper airflow and fuel mixture delivery to the combustion chamber. If you experience issues like idling, stalling, or difficulty starting the engine, it may indicate a broken carburetor adapter. Additionally, look for fuel dripping or a strong odor around the carburetor area. Failure to replace the adapter will result in air and fuel leaks. Replacing it will restore the proper airflow and fuel mixture to the engine, allowing it to operate efficiently and effectively. To do so, first make sure the engine is cool and disconnect the wire and boot from the spark plug. Detach the air filter cover and use a flathead screwdriver to detach the fuel lines from the carburetor ports. Unscrew the mounting screws of the carburetor using a torx bit. You can then peel off the gasket covering the adapter and remove it from the machine by unscrewing its fasteners. Please note that this OEM replacement part is sold individually before adding it to your cart.

Poulan Leaf Blower / Vacuum Carburetor This is a genuine OEM replacement part, it is sold individually. It is used on a variety of Gas Powered Equipment. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. If the engine won't start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. Pull the starter rope. If the engine starts and then quickly dies, the carburetor is likely the problem.