Pole Saw Springs and Shock Absorbers

Pole Saw Trimmer Spark Plug Coil This spark plug wire, also known as a spark plug coil or spark plug cap coil, is compatible with various makes and models of hand-held outdoor power equipment and is sold individually. This wire is installed within the spark plug boot and attaches to the spark plug for the ignition of your equipment. The spark plug wire is often exposed to extreme heat and excessive vibrations, so through normal wear and tear, it will likely break down. If your equipment is having difficulty starting or has general performance issues, the wire may be the reason why. To replace this wire, make sure your equipment is off before removing the wire and boot from the spark plug. Remove the boot from the wire and install the new wire within the boot before re-installing the boot back to the spark plug.

Pole Saw Spring This OEM spring, also known as a recoil or rewind spring, is housed in a container and is used to retract the starter rope on various lawn equipment models. Over time and through use, the spring will eventually lose its tension, and will break. If your starter rope has no resistance when pulling it, the starter spring is likely broken. Measuring at approx. 3-inches by 3-inches, this spring is suitable for use with a variety of lawn equipment models and is sold individually.

Pole Saw Spring-rewind This item has been sourced from the original manufacturer and is intended to be used with trimmers, edgers, and blowers from Echo. The metal spring is part of the recoil starter assembly and is used to rewind the starter rope after it has been pulled to start the motor. This item is sold as an individual replacement part.

Pole Saw Throttle Return Spring This spring is sourced directly from the original equipment manufacturer for use with Echo handheld trimmers and edgers. It is an important component that applies tension on the trigger-throttle. Over time it may wear out and lose tension eventually requiring a replacement. To ensure the correct installation of this hardware, check the diagrams of your specific model. This high-quality spring is made of durable metal and is sold as an individual component. You will need a screwdriver to take apart the throttle housing when performing this repair.

Pole Saw Compression Spring 4 This is an authentic replacement part manufactured for use with Makita pneumatic nailers and jigsaws. The special compression spring is used with different types of equipment and the application of the spring varies depending on the model of equipment. This compression spring is available as an individual replacement part, please see model diagram for part location and usage.

Pole Saw Spring, Trigger This is an authentic Echo replacement part that has been sourced from the original manufacturer to be used with trimmers and power source attachments. The metal spring is used to apply torsion to the trigger to keep it in position and allow the trigger to compress when adjusting the motor's output. This item is available as an individual replacement part.

Pole Saw Return Spring This part is an authentic manufacturer-sourced replacement part which is specially designed for trimmers, brushcutters and blowers. This part is sold individually and made of metal. The return spring helps return the starter pawl back to the regular position after you are done starting the engine with the recoil starter.

Pole Saw Spring-trigger Return This is an authentic replacement part from original manufacturer. It is guaranteed compatible with the Echo tools listed below. This is a trigger return spring which attaches to the control handle and throttle trigger. During repair, be sure to note its positioning in relation to these other parts; correct orientation is essential for tool functioning. Springs are easily lost or broken so keeping a backup is a good idea. Sold individually.

Pole Saw Spring-lever Return This is a genuine Echo replacement part that has been sourced from the original manufacturer to be used with edgers and Trimmers. The metal spring Lever Return is used to provide tension on the Lever of the trimmer to work out properly. This part is available as an individual replacement part. You will need a screwdriver to replace this part.

Pole Saw Damper Spring

★★★★★

★★★★★

1 Review

Genuine Manufacturer Sourced replacement part used on a variety of Lawn and Garden Equipment. This part is made out of Metal and it is Sold Individually. Replacing damper spring could solve your problems or Starter rope being difficult to pull or Recoil starter not working at all.