Refrigerator Door Shelf Retainer Bar - Cut to Fit

cut brackets to size and snapped them into place with the caps purchased. I will continue to use PartSelect for all my appliance repair needs. Not only did I receive my order within 2 days but the cost was over half of what I have been paying for the local parts store to order for me. Thank you PartsSelect.

It took longer to remove the retainer bar from the packaging than it did to install it in the fridge.

Both left and right end caps were pushed into their respective places on the retainer bar and then the whole thing was snapped into place on the door of the fridge.

Super easy!

Put them together and (do this carefully, as they are light-duty plastic; the reason the originals failed) snapped them into place. Parts were factory-origninal, easy to figure out. Delivery time was exceptional, packaging great.

I snapped off the old, broken parts of the shelves and in the side by side fridge, I just popped on the new shelf. In the White Westinghouse freezer on top fridge, I had to remove (it snapped right off) the broken side shelf retainer bar end cap from the fridge and remove the broken piece piece of plastic from existing shelf retainer bar end cap that was stuck in the retainer bar. I used a letter opener to help get it out. Then I snapped the new door shelf retainer bar end cap into the bar, and snapped the bar end cap back to the door. Both repairs took less than 5 minutes..........and I am a female who isn't very handy!!

snap in place

Pulled refrig away from wall, shut off water supply. Removed two screws holding the old water value on the back of the refrig. Removed the two water lines from the value. Hooked water lines up to the new value and bolted the two screws and the new value on. Turned on water and pushed refrig back into position. Simple and it worked. No more huge blocks of ice. I have Cubes!!!

Took the old ones off and installed the new ones. Simple repair

The repairs were easy. The braces and end caps went together fairly easy. The freezer brace needed to be cut to fit but was easily done. 15-30 minutes was all that was needed.

I ordered two of the long refrigerator shelf door bars and cut one of them to fit the freezer shelf door because that ready-made door bar was very expensive. The fit after cutting and notching to receive the end caps went very well.

The refrigerator that came with the purchase of my house had a missing retainer bar in bottom shelf of fridge and a duct-taped retainer bar in freezer. When parts came, all I had to do after removing the duct-tape, was slide up the broken end cap to pop it off then, snap the retainer bars into the end caps and slide them down into place. No tools necessary. Should have done this two years ago when I bought the house!