Compressor Overload and Relay Kit 12002782

ohms-tested the overload relay and PTC component BUT failed to test the compressor. Turns out that it was the compressor was bad and a do-it-ourselfer won't be able to change out this component. Must be licensed to install freon back into the lines once they are separated. Also specialized soldering equip. and freon equipment is needed ... Read more to perform this task. And if you add too much or the wrong kind of product or don't accurately install the bullet-piercing valve you can risk damaging the unit. So, ALWAYS Oms-test the compressor while testing the capacitor and overload and relay kit!!

remove back lower panel using nutdriver. Locate and remove Relay and Overload parts from side of Compressor which were located inside a small white box shaped cover unti held on by a spring clip. Attach new Relay and overload to 3 pin terminals on side of compressor. Attach 1 white & 1 orange/white wire to relay terminals. Attach supplied ... Read more white jumper wire to Overload and other end to Blue wire. Instal new cover supplied with kit replacing old box type cover.