Water Dispenser Actuator 241682001

My 12 year old did this himself. Took plastic cover off and removed old part and screwed in new part.

My Man looked on YouTube - took the cover off and successfully replaced the dispenser arm. The hardest part was placing the spring back correctly. I'm so proud of him. Saved us a ton of money and it's better now that it ever was

The video was an amazing tool. I have never repaired anything on an appliance before and I was able to follow the instructions easily.

It was a breeze. Very easy to do took longer to tale part out if box than to make repair. I love part select.

take front panal off and unplug the electrectal tail to the front panal then unscrew the 4 hold down screws then take out broken part and then replace with new part and re-assemble front panal

1. Turned off water and unplugged refridgerator. 2. Removed the drip tray. 3. Removed the 3 screws under drip tray. 4. Pulled facing off the fridge. 5. removed the 3 screws at top of dispenser. 6. Pulled the dispenser out far enough to remove broken actuator. 7. Removed 2 screws holding broken actuator in place. 8. Removed ... Read more broken actuator and replaced with new actuator. Re-attached everything in reverse. Be aware that there are two serial numbers on the labels inside the refridgerator. The one with the letters at the end tells the color of the refridgerator. I had to return and reorder. The company emailed me the instructions and that went well too.

Easy to replace

Remove ice and water front panel, removed water actuator from housing, installed new actuator.I highly recommend the Part Select Co. for fast delivery and accurate part selection.

After reading the reviews you have posted on your site I followed the steps others had taken. Everything worked out just fine. The reviews prepared me for the steps to take, otherwise I would not have been able to make the repair. The magnetized part holder was the key in holding the metal retainers until I could screw them in place.

I unplugged the refrigerator. I then removed the two screws that hold the element in place. I then removed 3 screws. After that, I removed 3 screws that were holding the dispenser in place. I took out the old part and put in the new. I then put back all of the screws.