Electric Control Board W11225084

The dishwasher starts and runs through a pre wash then shuts down

Dishwasher turns on automatically. Buttons will automatically come on and go off. Sometimes, the dishwasher will not turn off or turn on when buttons are manually being pushed.

Hi, my Maytag control board the part number of W11168783 REV B. I cannot see from image on your website in this link here https://www.partselect.com/PS12583931-Whirlpool-W11225084-Electric-Control-Board.htm?SourceCode=3&SearchTerm=W11168782 if it is the same part number as mine. Could you confirm? Would Part number W11168782 REV C replaces my part without problem?

Dishwasher stopped drawing in the water needed in a cycle. It is mildly steamy inside when door is opened mid cycle. When working properly steam would roll out, and ample water would be visible. Did rudimentary troubleshoot--water line, plugged in, no kinks in water line, unplug reset. Did not work. wash pods lay in the the bottom of dishwasher undissolved after cycles. Diagnostic mode yielded 1 pause 6 (or 6 pause 1). This sounded like it was either the control panel or the water inlet valve. I replaced the water inlet valve. and the problem changed. I could hear the dishwasher drawing in water. The cycle proceeded, taking what seemed a very long time. When finished pods in tray undissolved, dishes moist but unclean. What would be next? Control panel or ?

When in Quick mode, the dishwasher will finish the prewash cycle. Then when going into wash mode, it will fill up with water start washing then beep and drain the water and when shut down. When I use the Normal mode, it normally completes the full wash cycle but I had it fail to. In all cases, it always shuts down after all the water has been emptied. I've replaced the main board. Any ideas?

In all wash modes selected the evacuation pump comes on, then the machine fills, a click is heard, but does not begin to wash. No hum from the wash pump can be heard. Is the control board the most likely cause.

Dishwasher turns on I can here the pump turn on and the water drain but the arms are not spinning and it does not come out of wash mode, I have change out the motor pump. next on my list is the control board. just want to make sure i am on the right path.

Our dishwasher is having issues. The unit will run throuch the wash and dry cycles but sometimes will stop after the dry cycle and leave water in the bottom and other times it stops and it is empty on the bottom. It washes fine and the heat comes on fine. At the end the led on the door is to light up white to indicate its done but it doesnt do that anymore. Sometimes its like it is done with no led lit and other times the cancel button light is on like it is stuck in a cycle. Any thoughts? Thanks!