Module Cover Label 240570237

Pry loose a corner and continue to peal away the old label. Carefully remove the backing on the new label. Starting from the top, align the new label. Press it down to remove any air that may be trapped behind it.

Took out old Ice container assembly without any tools and replaces with a new assembly. After that ice despensed properly.

replaced the cracked Module Label Cover with new one. Attached with adhesive as it was previously.

Very easy to peel off old label and apply new self adhering label. Looks great ! I have ordered other parts from PartSelect and have been very satisfied. Always the right part the first time !!

First of all, I ordered in the afternoon and the part was on my doorstep the very next day, amazing shipping. I shopped all over and this was the best price by a few dollars. I hope I never need any other parts, but if I do, I will come back to buy my parts here.

I pried the old cover off with a pocket knife and carefully ins ... Read more talled the new one. Now it looks great and it only took me about 5 minutes.

I removed the three screws at the bottom of the ice maker dispenser tray and took the entire unit off. I unplugged the electrical connector, removed the damaged module face plate and replaced it with the new one. Put everything back in reverse order.

the tray just pulls out, with a little encouragement. then the new one was put in place. the module label just peeled off and i stuck on the new one. new frig looks fabulous. i used krylon for plastic to paint the rest of the housing for the ice/water dispenser. i chose not to paint the water tray as i feared the frequent wasking wou ... Read more ld wear on the painted part. new frig just looks fabulous !!!

Label cover was glued on and you simply pull it off and replace it with the new one. That takes about 2 minutes! The front panel was dented and all you have to do is pull off the rubber trim on the bottom and replace the panel. The dishwasher looks new!!

thanks
dan