Blender Blade Seal WP9704204

I took off the worn piece. Screwed on the new one. I would have liked and would have paid for, a fitted tool to the drive shaft; which would have made the repair far easier.

To start with the coupling, I followed the directions by using a flat screwdriver and a thick towel. I placed the towel under the screwdriver to protect the base unit from damage as I pivoted 1/2 of the tip under the coupling, pulling it up as I went around until the coupling popped off. Then I cleaned the remainder of any metal left behi ... Read more nd. Then I attempted to screw the coupling on clockwise but the screw opening was slightly to small. So I plugged in the unit and held the coupling with the screwdriver in place and turn the unit on stir and it screwed it on clockwise.
Next, the seal was replaced at the bottom of the jar. And I was finished. Easy as pie.

I removed the bottom part of the blender and added the seal to the blade area, screwed it back on and voila! I appreciate that it was so easy.

I used a flat screw driver and gently and forcibly removed the part as recommended in the instructional manual. Putting the replacement part was not at all difficult. With the new part in place the blender now works like new.

followed instruction, prying off old coupling and screwed new coupling on less than 5 minutes. Parts came in a timely manner. great service, satisfied customer

I followed the included instructions.

Removal of the old coupling was easily done by gently prying it up. The threads on ot are much softer that the shaft.

Screwed the new coupling on and done.

I also bought two of these couplings as the rubber on it WILL break off again.

No tools required, just unscrew the old jar and seal and twist on the new one. Very simple.