This oven door seal creates a protective seal around an oven door to prevent heat from running out of a closed oven and keeps room air from entering the oven. This part is 17.5 inches long and made of rubber. The metal hook on both ends of the seal is there to keep it in place. Remove screws to take off old seal using pliers and replace it with the new seal. For detailed installation instructions and accurate guidance, refer to the diagram provided by the manufacturer. As a safety precaution make sure to unplug oven from power source and wait for oven to cool before starting this replacement project.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part works with the following products:
Wall Oven, Range, Refrigerator.
This part works with the following products:
Magic Chef, Maytag, Hardwick, Admiral.
Part# WP7212P006-60 replaces these:
AP6010758, 0773203, 0S00644099, 0S04301099, 1726200, 1726201, 1726203, 1726207, 1726220, 1726243, 1726245, 1808218, 1808219, 1808222, 1808228, 2207F015-50, 550048, 551163, 7212P006-60, 7212P018-60
...
Show more, 790059, Y0773203, Y0S00644099, Y0S04301099
Show less
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Steven
May 4, 2018
The upper rubber strip measures 19 inches not 17 1/2. Does the replacement part stretch? The two side strips are ok. The upper strip as well as the sides are not located on the glass oven door but on the frame.
For model number Magic Chef 90HN 4KVW
Hello Steven, thank you for your question. The manufacturer recommended replacement parts for the door seals are WP7212P006-60 for the top and bottom and WP7212P015-60 for the sides. The top and bottom seals will stretch a bit to form a good seal. I hope this helps!
6 people found this helpful.
Was this helpful?
Thank you for voting!
Elizabeth
July 3, 2022
Seeking a horizontal top gasket seal for the above Magic Chef model. It is 19.5 inches long.
For model number 568A-40W
Hello Elizabeth, thank you for your question. There is a Seal PS11743942 that sits on top of the glass window pane. We hope this is the seal you were asking about. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 3.9 / 5.0, 2 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Tenant complaind that oven door gaskets were worn out.
No "repair" needed, just parts replacement. The oven door had (3) rubber-like gasket strips, held in place by metal strips at each end of the gaskets, which fit into 3/16" diameter holes in the oven frame. The (1) gasket ordered for the "horizontal"/upper position was an exact replacement and fit like a charm. However, the pair of (2) gaskets ordered for the "vertical"/sides position were not designed for this range and needed MODIFICATION in order to be installed. Specifically, the metal strips at the end of the gaskets were TOO WIDE to fit into the existing holes in the oven frame. I was able to make the metal strips Using a pair of needle-nose pliers and a pair of nipper-pliers, I was able to flaten-out each of the four metal strips, cut each metal strip [basically in half], re-bend the halfed-strips into "hook" shapes, and then re-insert the metal hooks into the existing 3/16" holes. So far, so good; no complaints from the tenant!
we had to soak the certain parts of the seal to straighten it so while that was being done we took the screws out and took off the old seal. then we put the new seal on and put the door all back together.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Andrew H - June 19, 2022
Verified Purchase
Part does not fit
Ordered this part -- a door seal for an older Maytag oven -- based on the unit's serial number, but the hooks on the ends of the seal I received are too large for the holes in which they need to go. Not due how that happened. Complete waste of time and money.
August 6, 2022
Hi Andrew,
Thank you for your review. Please accept our apologies for this situation. We will be in touch with you shortly regarding your order.
★★★★★
★★★★★
Suzanne L - June 25, 2019
Verified Purchase
Not received!
Was told shipped to wrong address...as of today have not had credit card refunded! Almost 30 days!
June 26, 2019
Hello Suzanne,
Thank you for leaving a review on the part ordered. I have sent you an email in regards to the order and the refund . Hope to hear from you!
★★★★★
★★★★★
Charles R B - February 21, 2019
Verified Purchase
so far, so good.
This is the second or third appliance part, this one for an obsolete mobile home oven, so far with consistently good results. I like the parts breakdown so i can get a good view of the part in exploded view to verify correctness. Came quickly and fit perfectly. Looked just like the original. Price was high, but for hard to find parts for discontinued appliances, that is expected, and not excessive in this case. The parts i got for newer appliances were reasonable. Thanks.
★★★★★
★★★★★
Shirley F - January 10, 2019
Verified Purchase
Easy repair and the part was perfect.
The part sent was perfect and the oven is working fine now. Thank you so much
★★★★★
★★★★★
Cleo L - October 10, 2018
Verified Purchase
Seal too long
Even though I supplied the name plate data on the oven, the seal was too long. I returned the seal and was credited. No harm no foul.
★★★★★
★★★★★
William H - October 9, 2018
Verified Purchase
Pretty easy repair
Everything was great about the part and the speed of delivery. Only problem I experienced was that the metal ends of the door seal were three times as large as the holes they went in.
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11743943
Manufacturer Part Number: WP7212P006-60
The Fix App makes it easy to manage all your stuff in one place. Just snap a photo and we'll find and store your user manuals, receipts, and product information in one easy-to-find place!
"Like magic. I took a picture of the model number on my refrigerator, and the app identified it right away … Very convenient. I'm impressed." ★★★★★ - Clever Jeff