This white gasket is used to seal the door when closed to keep the cool air inside and the room air out.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part fixes the following symptoms:
Door Sweating | Fridge too warm | Leaking | Fridge runs too long
This part works with the following products:
Refrigerator.
Part# WP61004010 replaces these:
AP6010014, 61002056, 61004010
Customer Reviews
Average Rating:
★★★★★
★★★★★
2 Reviews
4.5
Filter By Rating:
5 Stars
1
4 Stars
1
3 Stars
0
2 Stars
0
1 Star
0
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Robert O - March 31, 2020
Verified Purchase
Simple repair - did it without removing door. Part arrived in 3 days.
The video for replacing the door gasket showed removal of both doors - the upper freezer door and the lower fresh food door. If the fridge was not in use (i.e. empty) I would have removed the doors. I left the fridge running and covered the fresh food section opening with a large piece of cardboard I got at the grocery store - found a big cardboard sheet from a pallet of water bottles. Used some masking tape to hold the cardboard cover in place. I suppose you could do without the cardboard cover as food wont spoil in the ~20 mins needed to do gasket replacement. Emptied the door compartments and removed the shelving parts (washed the parts). Removed door panel and replaced gasket - would have been easier with a helper to hold things up, but I did if by myself. Only issue was at bottom of door - the large, thin gasket lip was sagging and interfering with door jamb. Loosened screws to stretch gasket out a bit. Used 3 bits of masking tape to hold up the gasket lip so door closes properly (remove tape after gasket settles into place).
★★★★★
★★★★★
Gary Y - September 19, 2018
Verified Purchase
Door Gadket
Correct part, but was difficult to check on the parts list. Took 3 plus weeks to arrive, cost was more than was expected, as there were no other replacement item available.
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 3.1 / 5.0, 14 reviews.
What's this?
Sort by:
< Prev
1
2
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Old seal was pulling apart, door wouldn't seal tight.
Having 2 people makes the job a snap. On our model the freezer door had to be partially removed so the other door can be lifted off, then slightly tighten freezer door in place. Lay door flat and remove the 36 screws & gasket making sure the new gasket slots are tucked under to match up with screw holes. We started all the screws & came
... Read moreback and tightened firmly. Loosen the freezer door and set the bottom door back in place, make sure doors clear each other and tighten down. Finished! I took the advice of another post and put gasket in clothes dryer for about 5 minutes,helps a bunch. Start to finish,30 minutes. Taking food out of door & replacing.
Read less
Chuck from ORANGE PARK, FL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Socket set
3 of 3 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Cracked Gasket
No need to repeat the other directions, everyone is spot on with exactly what to do, the ONLY thing I want to add is that prior to putting the new gasket on, throw it into the dryer for a few minutes to make it more pliable..... My problem was that it didn't seat very well, be patient, after 2 days and keeping pressure on it over night, i
... Read moret was a perfect fit !
Read less
Robert from RIO GRANDE, NJ
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver
4 of 4 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Leaky Gaskets (Freezer & Refrigerator0
Took doors off, placed on counter, removed the screws ans installed gaskets seals.
The repair goes much easier if the door is removed. The door is bulky and that's the difficult part. Once its on the table, unscrew to get old one off, put new one in place and re screw. (there are many screws) Then bulky door needs to be placed back onto the refrigerator. Again difficult positioning, weight, bulky. The door comes off and
... Read more goes on very easily (2 mins to get off, 10 to put back on). Just 3 lower screws. This job could have taken less than an hour if I had started with a removed door.
Read less
David from Agawam, MA
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Socket set
11 of 13 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Torn food door gasket
Removed screws securing the inner door compartment, installed new gasket on door compartment and reinstalled inner door compartment.
BILLY from DANIA BEACH, FL
Difficulty Level:
Really Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver
1 of 3 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Refrigerator Fresh Food Gasket
I merely removed the old one and replaced the old one, I luckily had a ratcheting screw driver which made things go alot quicker as there were 36 screws holding the gasket on the inside of the door, also I had to replace some of the screws that I tightened as they stripped out in the door metal, I GOT SOME OF THE SAME DIMENTION with a sli
... Read moreghtly larger thread new screws and carefully screwed them in with no problems at all. Thank you for your professional speedy service. I will surely contact you again when I need parts for my appliances even if I m not the MAYTAG repair man.
Read less
Malcolme from Saint Petersburg, FL
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
2 of 3 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Door seal worn out, needed replacement
To make instalation much easier, I removed the door and layed it on a table. I then remobved about 45 screws,removed the inner door section, removed the seal and installed new seal in reverse order being careful not to over tighten the screws. Having the door lying on the table made it much easier to place the gasket in place and make any
... Read more minor adjustments. I then replaced the door and everything workes just fine.
Read less
ROBERT from BASSETT, VA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
33 of 34 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Refrigerator door weatherstripping torn
Removed all screws on the door that retained weatherstripping, removed weatherstripping and inside of door. Inserted new weatherstripping, lined up inside of door and loosely re-installed screws. After minor alignment adjusting, went back and tightened all screws. Replacement part was a perfect fit.
The first order of business was to find a supplier for the gasket and to make sure that the right one was ordered. This was done with out a hitch @ Part Select and at a cost less than the retail stores. The right Gasket was ordered thru Parts Select
Only difficulty was to start the install of the replacment . Need to star
... Read moret at the hinged corner of the door Top & Bottom for a good fit and less hassel.
Thank you Part Select for the service.
Alan E. Bischof Houston Texas
Read less
Alan from Houston, TX
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver
8 of 10 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Old gasket leaking
The gasket is sandwiched between the main door and the shelf assembly.
What holds them together is 42 1/4in hex head self tapping screws that run along the edge (each one is finger tight).
I would highly recommend a power drill with a 1/4 hex socket to remove the screws. It makes things much faster. Be careful when
... Read morescrewing the screws back in with the power drill(you only want them finger tight). If the screws are too tight,the gasket will bulge out in places.
At first the seal may feel weak. Keep the door closed for a couple of hours and the seal should improve.
Read less
Laurence from San Diego, CA
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Socket set
6 of 7 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
2
Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
5 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Bob
August 26, 2017
Put the new gasket on but now the door doesn't even shut completely. Am i missing something ? Gasket seemed to go on seamlessly , door just doesn't shut or remain shut ... as if the magnet is not strong enough. Any thoughts / suggestions ?
Hello Bob, thank you for contacting us. We have a how to video on our youtube channel that will show the installation of this exact door gasket. You can click the link below, hope this helps!
https://www.youtube.com/watch?v=NS7vmgyTJfc
12 people found this helpful.
Was this helpful?
Thank you for voting!
Jill
October 1, 2021
Does the gasket have a magnet strip built in?
For model number MTB2154DRW
Hello Jill, Thank you for the question. Yes, the Gasket has a built in magnet to help seal the door. We hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Jennifer
March 15, 2023
Does this gasket fit my Amana refrigerator?
For model number ATB2135HR
Hello Jennifer, thank you for contacting us. Based on our research, the fresh food door gasket, part number PS11743190, is compatible with your model. We hope this information helps!
Was this helpful?
Thank you for voting!
Miller
October 16, 2019
Knats keep getting side of both freezer and fresh food compartment. Fresh food compartment seal is about 3 years old. Freezer seal came with unit in 2000. Question is why and how are these bugs getting in the unit? Preparing to get new seals, but they are not cheap. Thanks for any advice.
For model number CT21A5
Hello Miller, thank you for writing. Gnats, or fruit flies, are drawn to fruit, plants and standing water. They have likely laid eggs somewhere inside of your refrigerator. Unplug the refrigerator and remove any drain traps and covers from inside of it and allow it to sit to dry out. After it dries out, spray the entire fridge with a spray cleaner that has bleach. Cover with tape any holes you discover inside the refrigerator that look like good possibilities for the flies to be breeding. Let the refrigerator sit for a day, then clean it with soap and water and plug it back in. I hope this helps!
Was this helpful?
Thank you for voting!
Dave
January 10, 2020
Hello. Will this gasket work on my old Magic Chef freezer door ? Thanks. The dimensions of the old gasket are length: 28.5 inches x width: 20 inches.
For model number FFTR1814VW
Hello Dave. Thank you for the question. Sadly we do not have any information on the model number you provided. Could you please verify the number you provided us with? If it is correct I recommend contacting the manufacturer and seeing if they could provide you with a part number then you are always welcome to check back to see if we carry the part. Hope this helps!
Item is in stock and will ship today if your order is placed before 4:00 PM Eastern Standard Time.
If your order is placed after 4:00 PM EST, the in stock items will ship on the next business day.
On Order
Item is not in stock and usually ships 3-5 business days from the time you place your order.
Special Order
Item is not in stock and usually ships 10-15 business days from the time you place your order.
NLA - No Longer Available
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
[{"position":0,"name":"Home","title":"Home","url":"/"},{"position":1,"name":"Refrigerator","title":"Refrigerator","url":"/Refrigerator-Parts.htm"},{"position":2,"name":"Seal or Gasket","title":"Seal or Gasket","url":"/Refrigerator-Seals-and-Gaskets.htm"},{"position":3,"name":"WP61004010","title":"WP61004010","url":""}]
You added 1 item to your cart
✖
$
Qty:
Total item(s) in cart:
Order Subtotal
$
*Taxes and shipping will be applied during checkout
