Basket Hub Kit W10820039

Hello Randy, Thank you for your inquiry. At this time, we do not have a video for this part, To replace the basket hubs, remove the cover from the agitator cap with a flat blade screwdriver. Pull the cover inside the agitator off, then take the agitator bolt off, use a 7/16 inch socket with a long extension and hold the tub so it does not turn. Take the agitator off, then reach in and lift out the lower part of the agitator out. Now you can access the basket hub. You may want to put towels down to cover the drain holes to make sure that the screws don't fall down the holes. Use a philips screwdriver to remove the screws, hold the tub again to keep it from spinning and be careful not to strip the screws as you are taking them out. Pull the hub out, it should come out in two pieces-a larger driven hub and a smaller white drive hub that has the gear teeth on top, pull both out. Since the kit comes with two types of driven hubs, compare the old one with the ones in the kit to see which one you should use. Put the smaller white driver hub in first, then the larger driven hub in, lining up the screw holes. Replace the screws, then the lower and upper parts of the agitator. Tighten down the agitator bolt, then replace the cover and cap. Hope this helps!

Hello David, thank you for your question.The bearing for this unit comes in a kit. The kit part number is W10435302. Please enter the part number into the site for current price and availability. Good luck with your repair!

Hi Sam, Thank you for your inquiry. This could be one of the parts that would fix that problem. I would suggest also looking at your suspension rods to see if they are still in good condition as well. Good luck with your repair.

Hi Paul, Thank you for the question. I suggest replacing the Basket Hub Kit.This kit includes one driver hub and two driven basket hubs. The basket hub is located under the agitator. If your washer is not agitating or spinning properly, the hubs will need to be replaced.Good luck with the repair!

Hello Larry, thank you for your question. We would recommend replacing Part Number: W10820039 Basket Hub Kit that can cause the noise and allow for the oil and grease to come into the tub. You will want to check both the Stator part PS11754517 and the Rotor part PS993018 for your model as the cause of the grease. We hope this helps.

Hello Tim, thank you for your question. We would recommend replacing the basket hub kit and the bearing and seal kit in this appliance. The bearing kit is part number W10435302. To complete the bearing and seal installation a bearing install took kit may be needed which is part number W10447783. I hope this helps!

Hi Larry, Thank you for your inquiry. It may fix that issue, I would suggest also taking a look at your suspension rods. They could also be causing noise in your appliance as it is spinning. Good luck.

Hello Justin, thank you for your question. It sounds like an issue with the sensor PartSelect Number PS11749664 and basket hub kit PartSelect Number: PS11723155. The sensor helps to ensure the load of clothing stays balanced during the wash cycle, that part failing could cause the un level code to happen. The noise at the end of the cycle could be caused by the hub kit. I hope this helps!

Hello Rob, thank you for inquiring. For this symptom you will want to replace either the Tub Seal and Bearing Kit part PS3503261, the Hose part PS1485613, or the Drain Pump part PS5136124. We hope this helps.

Hello Frank, thank you for writing. Yes, this may fix that issue. It is located under the Washplate, so the Washplate will have to be removed to install the Basket Hub Kit. You may also want to consider the Suspension Rod Support part PS3502189 for your model. We hope this helps.