Quick Question!

Have you ever purchased from PartSelect.com before?

Models > ZGU36KSK1SS

ZGU36KSK1SS General Electric Cooktop - Overview

Get Parts and Repair Help for ZGU36KSK1SS

If you know the cooktop repair part you need, you can browse the list of all parts on the ZGU36KSK1SS, or you can search by name or part description. You can also find your part by where it is located on the ZGU36KSK1SS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZGU36KSK1SS

[Viewing 3 of 3]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Grate Foot

The grate foot pad attaches to the bottom of the burner grate to prevent the cooktop from being scratched. It protects the stove top by cushioning the grate on your gas range. Over...



Sold individually.



This screw is sold individually.



Sold Individually.



Also known as spark electrode. This part helps your burner ignite and produce flame.


Gas Pressure Regulator

This comes set from the manufacturer for Natural Gas. It also includes the conversion to Liquid Propane. This valve automatically cuts off the flow of gas at a certain pressure.


SCREW 6-32 MCH FHT15 984


Burner Gasket


Control Knob Seal

Sold individually. This seal prevents any leaks from getting under the cooktop or into the switch area.


Burner Gasket

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burner wouldn't light

  • Customer: Jeffrey from Freehold, NJ
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 47 of 52 people found this instruction helpful
I removed the old igniter by working a thin screwdriver under the edge of the igniter, and carefully prying it up. I then used pliers to pull off the electrical wire. Connected up the new igniter, and pushed it back into the hole. A very simple repair.

I've replaced 2 igniters on this stove. My symptoms were that when I tried to light one of the ... read more

Grate Foot had worn out

  • Customer: Kathryn from Star City, AR
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 19 of 23 people found this instruction helpful
A rubber grate foot on my range top had worn out. I pulled the worn foot out and installed the new grate foot with no tools or accessories. Good as new! Now I don't have to worry about the grate scraping my range top and scratching the paint. I also ordered extras so I won't have to wait if another wears out. read more

Replacing Spark Igniter

  • Customer: RICHARD from HERNDON, VA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 10 of 13 people found this instruction helpful
Pulled the old one out. Disconnected the wire. Repaired the frayed wire cover with Liquid Tape. Connected the wire. Inserted the new part into the hole. This is after installing a new spark module earlier. But that was dumb easy too. So for about $100 bucks in parts and an hour of my time I saved myself the appliance repairman money and agonizing scheduling... read more