Y2550EC (41AD25SC900) Yard Machines Trimmer - Instructions

Removed the two screws holding the fuel tank to the main unit. Removed the two fuel lines and any stuck on rubber. Installed and installed two screws to mount the new tank. Slid fuel lines on their respective connectors. Done.

remove two screws holding old air cleaner housing to carburetor and manifold. The carburetor will come off but don't worry as long as gasket does not tear. line up new housing, put the 2 new screws in and tighten. put new filter in and the new cover on and done

Air filter has a tab to open cover just press the tab to remove take old filter out and replace it with new one then reinstall the cover and you're done.

The fuel tank is held in place by 2 screws. Simply take the screws off and pull off the fuel lines.
Take the new fuel tank. Put it in place and screw the 2 screws in to hold the fuel tank.
Connect the fuel lines and you're done.
This is the easiest repair I have ever done on any of my lawn equipment.

Remove the smaller set screw that keeps the gearbox aligned on the shaft. Remove the two screws on the gearbox that are closest to the engine. You may have to loosen the other 4 screws,but they are not necessary to remove, as the new gearbox comes with those 4 screws in place. You can then slide the gearbox off the shaft. Clean all dirt and debris off the end of the shaft. Install the new gearbox the same way you removed the old one. Install the set screw to realign the gearbox on the shaft. Then install the two screws closest to the engine. Tighten all 7 screws on the gearbox and shaft accordingly. Start your engine and give her a go. Gearbox assembly comes pre-installed with trimmer line already so you're good to go.