WTA4410CN (01) Bosch Dryer - Overview
Sections of the WTA4410CN
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
BELT-DRIVE
PartSelect #: PS8715044
Manufacturer #: 00437367
This belt drive is a replacement mechanical component designed to transfer power between moving assemblies within an appliance. It supports smooth, efficient motion and is commonly replaced when compo...
$89.60
In Stock
Programming Knob - White
PartSelect #: PS8726236
Manufacturer #: 00604440
This knob accepts a D-shaped shaft.
No Longer Available
Questions And Answers for WTA4410CN
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Dryer won't heat
If your Bosch dryer isn't heating, open the back of the dryer and there is a temp sensor that if it gets too hot, it trips. push the red button to reset. If it trips again, check all your vent tubes for lint build up. If after cleaning it still trips, you may need to replace the heat sensor. After tripping a few times it will get weak. O
... Read more
rder a new sensor and replace it. Only two screws and two quick connect wires.
Read less
Parts Used:
-
Robert from Key West, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
3 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!