WM2301HR LG Washer Parts & Repair Help | PartSelect
Quick Question!

Have you ever purchased from PartSelect.com before?

Models > WM2301HR

WM2301HR LG Washer - Overview

Get Parts and Repair Help for WM2301HR

Manuals & Care Guides for WM2301HR

Click to download
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
(55)
PartSelect #:PS3579318
Manufacturer #:4681EA2001T
The drain pump and motor assembly may also be known as the washer drain pump, and is a part for your washer. The drain pump helps expel water from the washing machine. The drain pu...
$64.14
In Stock
(18)
PartSelect #:PS3527427
Manufacturer #:5220FR2006H
The hot water inlet valve on your washing machine controls the water flow into the washer. This inlet valve has a standard hose fitting inlet and one water outlet. The water inlet ...
$18.11
On Order
(33)
PartSelect #:PS11728995
Manufacturer #:5220FR2075L
The cold water inlet valve on your washing machine dispenses the cold water and bleach into the washer in the prewash cycle. This inlet valve has a standard hose fitting inlet and ...
$49.03
In Stock
(5)
PartSelect #:PS3523345
Manufacturer #:4738ER1002A
This is a tub-to-pump drain hose for a front load washer. The hose features flexible bellows which allow it to expand and contract when necessary. It carries the water from the tub...
$22.22
In Stock
(9)
PartSelect #:PS3522855
Manufacturer #:4036ER2004A
If you notice your washing machine is leaking water from the top of the transmission, it might be due to the gasket being damaged or worn down. When replacing your gasket, consider...
$11.00
In Stock
PartSelect #:PS11711139
Manufacturer #:MAP61913708
$36.59
In Stock
PartSelect #:PS11711138
Manufacturer #:MAP61913707
No Longer Available
(11)
PartSelect #:PS3522644
Manufacturer #:3891ER2003A
This is a replacement detergent dispenser for your washer. It stores the detergent, and then dispenses it into the washer at the appropriate point in the wash cycle. If the deterge...
$11.00
In Stock
(4)
PartSelect #:PS3524977
Manufacturer #:4986ER0004F
Also known as a door boot seal or bellow and comes with a drain hole.
$70.93
In Stock
(1)
PartSelect #:PS3522859
Manufacturer #:4036ER4001B
This is a seal for a washer tub. It creates a seal between the front and rear halves of the washer tub to prevent the appliance from leaking. If you notice leakage between the two ...
$11.26
In Stock
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Washing maching wouldn't drain

  • Customer: Jorge from Apple Valley, CA
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 486 of 616 people found this instruction helpful
Removed the top of the washer by removing the 4 back screws and 2 small brackets. Then I removed the front panel, this was actually the hardest part, 2 screws and 8 tabs that you pop out carefully from the top of the panel. I only disconnected the power button and was able to rest the panel on top of the washer. The rest of the washer came apart quickly just... read more

LE Error Message and won't spin drum properly

  • Customer: Mark from Harrisburg, PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Socket set
  • 194 of 257 people found this instruction helpful
I first tested the motor per the service manual. I checked the resistance between the terminals of the 3 pin connector. It's supposed to be 5-15 ohms. The motor checked out so I replaced the main electrical board. It turns out that wasn't the problem. After a brief web search I found out that the hall sensor (which is attached to the motor stator) was t... read more

Bearing seal out causing bearings to get wet and very noisy

  • Customer: Todd from STOCKTON, KS
  • Difficulty: Really Easy
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set
  • 20 of 21 people found this instruction helpful
Watched a short video to figure out to remove panels. After panels were off I removed as much as I could from the inside of the machine. This was not completely necessary however for an extra half hour it made inspection, cleanup and removal of tub housing out the front of the machine much easier. Once out, I split the two halves of the outer basin and s... read more