W25CF ((967184201)(2012-11)) Poulan Trimmer - Overview
Sections of the W25CF
[Viewing 2 of 2]
Keep searches simple, eg. "belt" or "pump".
Engine Fuel Filter
PartSelect #: PS9285148
Manufacturer #: 530095646
This Genuine OEM fuel filter is designed to maintain the performance and longevity of your equipment by preventing dirt and debris from entering the carburetor. Located inside the fuel tank, this esse...
$9.16
In Stock
Fuel Tank
PartSelect #: PS12646115
Manufacturer #: 581263701
This genuine fuel tank assembly is an original replacement part sourced directly from the manufacturer and is commonly used in Craftsman trimmers and weedwackers. Made from high-quality plastic for du...
$23.72
Special Order
Trigger
PartSelect #: PS12659637
Manufacturer #: 530058000
Genuine Weed Eater replacement part, this item is sold individually. The 530058000 Trigger is inside the handle of the trimmers shown below. It connects to the throttle cable which controls the speed ...
$8.18
Special Order
Flywheel
PartSelect #: PS16365732
Manufacturer #: 545221701
This flywheel is an authentic manufacturer replacement part for use with lawn and outdoor equipment. The flywheel is a heavy, circular disc that has magnets that create an electric charge sent to the ...
$38.92
In Stock
Foam Air Filter
PartSelect #: PS16352697
Manufacturer #: 530057781
This is an Original Manufacturer Approved replacement part. This part is made out of Foam and it is sold individually. The purpose of the filter is to keep dust and debris from contaminating the carbu...
$7.64
In Stock
Start Spring
PartSelect #: PS16365370
Manufacturer #: 545008014
This is a genuine OEM approved replacement starter spring is specially designed for use with gandheld gas powered blowers and trimmers. The purpose of this spring is to retract the starter assembly on...
$15.27
On Order
Piston Ring
PartSelect #: PS16365561
Manufacturer #: 545154001
This metal ring in your engine, known as the piston ring, seals the gap between the piston and cylinder wall. It makes sure that the gases produced during combustion do not escape and that the engine ...
$6.40
In Stock
Ignition Module
PartSelect #: PS12628861
Manufacturer #: 578287001
This ignition module is a genuine OEM sourced item, it is not an aftermarket imitation. Ignition module supplies electric current to the spark plug. If the ignition coil is defective, the engine may n...
$36.90
In Stock
Screw Catcher
PartSelect #: PS9362595
Manufacturer #: 530015814
This is a standard hardware which has multiple applications based on your tool. It is sourced from original equipment manufacturer for use with a variety of power equipment. Please refer to diagrams f...
$6.40
In Stock
Cap
PartSelect #: PS12638387
Manufacturer #: 545202501
The fixed-line cap has been sourced from the original manufacturer to ensure quality. The cap is intended to be used with trimmers from Weed Eater. The hard plastic cap is used to secure the bottom po...
No Longer Available
Gasket Set
PartSelect #: PS12602552
Manufacturer #: 530071750
This is a Manufacturer Approved replacement kit used on a variety of Gas Trimmers/Pruners. This gasket set includes the major gaskets to replace when rebuilding the engine. Its purpose is to make an a...
No Longer Available
CARBURETOR ASSEMBLY
PartSelect #: PS18528963
Manufacturer #: 577135902
Genuine OEM replacement part, this part is sold individually. A carburetor basically consists of an open pipe through which the air passes into the inlet manifold of the engine. The pipe is in the for...
$58.00
In Stock
Questions And Answers for W25CF
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the W25CF
[Viewing 2 of 2]Will Not Start
Fixed by
these parts
these parts
Show All
Engine stops after a few seconds or minutes
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Clogged muffler
Remove the 4 screws holding the rear motor casing. Then you can take the easy route and drill through the front motor housing with a 3/8 to 1/2 bit in order to access the front muffler screw. If you want to work harder you must remove the motor from the shaft, remove the clutch assembly (this requires a long 15t torx bit, removing the spa
... Read more
rk plug to stuff the piston with rope or rag to seize up the piston, and then removing the front motor casing to access the front muffler screw). Once you access both muffler screws remove them with the t20 torx driver. Install the new muffler with the small gasket inside the housing, and the larger gasket/heat shield between the muffler and the motor.
Read less
Parts Used:
-
Rosanne from BRIDGEWATER, VA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
5 of 8 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!