Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This is a tub bearing and it is meant to work in conjunction with your washing machine. The purpose of this part is to aid in keeping the inner tub of your washing machine spinning smoothly during a w...
This split ring is supplied by the original equipment manufacturer, and it is designed to secure the tub bearing in washing machines. It is a circular metal ring, with an outer diameter of 2 inches. T...
This is a water hose clamp kit for a variety of appliances including dishwashers and washers. This is a genuine replacement part. The kit includes two hose clamps. The smaller of the two is 1 inch in ...
First removed front washer access panel. Next: removed top panel torx screws and disconnected lid switch wiring connector Next: removed washer top/lid Next: removed inoperative lid switch (two phillips head screws) Next: installed new lid switch and screws Next: installed washer top and connected lid switch wire c
... Read moreonnector Next: installed control panel and screws Next: tested installation Next: installed front washer access panel Easy repair. FYI, Parts Select had best price and part arrived within two days of ordering! Highly recommend them for your parts.
The screws were rusted onto the old lid. It wasn't difficult to get the other site off. I used PB Penetrating catalyst and it came right off. You'll need to grab the little plastic poker thingy from the old lid, so don't throw that away.
Take off front. Take off top. Pull off agitator. Pull off agitator coupler, after removing bolt holding in place. Attempt to remove hub nut, no joy. Wound up cutting the nut with a Dremel tool and chiseling the nut off. Closer inspection revealed a bad transmission. Due to the cost of the transmission, we will continue to use the machine
... Read moreuntil it completely fails.
