Models > SKSDR360SIS > Instructions

SKSDR360SIS (ASTLSGN) LG Range - Instructions

All Instructions for the SKSDR360SIS

Convection Fan stopped working, would spin but not continuously on its own

Unplugged oven electric and turned gas off. Removed all back covers from the unit. Removed the cover on the inside covering the burner and fan in the back of the convection oven. Removed the nut securing the fan to motor shaft with helper holding the motor. Removed the three electrical wires attached to motor, making note where they go. Removed screws mounting the motor to oven. Removed motor cooling fan and shaft spacer from old motor. Fit in same orientation on new motor. Replace all parts in reverse order, restore gas and electric, turn on and test.

Parts Used:

MOTOR,AC FAN

Barry from PIERRE, SD
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers

16 of 22 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

The Microwave was completely dead and wouldn't run, light up or anything.

I followed an old appliance repair forums post from 2008 that discussed this exact common issue with this LG model. It took me quite a while to find the info. Then I used the schematic diagrams on your website to find where the part was located inside the microwave. I removed the outer cover. I tested all components including the thermostat for continuity with a multimeter. I discovered there wasn't any continuity in the thermostat so ordered the part and replaced it. Everything works like a charm! Thanks for the great, fast service.

Parts Used: