SHX68T55UC (09) Bosch Dishwasher - Overview

The E:15 error code means water is detected in the pan under the unit. There are several ways this can happen.

In this case, it was caused by a bad inlet valve. It did not close properly and led to an overflow of water inside that eventually spilled into the pan underneath the unit.

I see now why the pump keeps running after this error. In this case, it would have led to a big flood in the kitchen if it did not.

I was actually able to run the unit while broke by manually operating the valve under our sink that provides water to the unit.

Be sure to turn off breaker before servicing. Don't get shocked!

Be sure to turn off water before starting! Or, you'll have a flood.

Anyway, I just pulled the unit out (was secured by 2 screws on the sides). I lifted up the insulation material on the left side to get at the valve. Pushed a little green tab to release the electrical plug. Then, use pliers to move clamp off the white water hose on the inside. Then, pull of white hose. This was hard in my case. Took a lot of force. Then, reach behind the unit and use pliers to unscrew water hose. Now, the whole gray panel there can pop out with some force. Then, slip the old valve out and slip new one in. Reconnect hoses and clamp. Note that I put some caulk on the connector where white hose goes. Not sure if needed or not.

Good luck!

pushed with thumb pressure and snapped rollers into place.....EASY

Removed the spray arm, front handle, and little clips from the old rack and installed onto the new rack. Was very simple.