SF9611KA570R Maytag Range - Overview
Sections of the SF9611KA570R
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Door Side Seal
PartSelect #: PS11743946
Manufacturer #: WP7212P015-60
Sold individually. Order quantity required.
No Longer Available
Oven Safety Valve
PartSelect #: PS2087949
Manufacturer #: 74010590
Once this valve senses the desired heat, this part will open up and allow the gas to travel to the oven burner.
No Longer Available
Drip Bowl & Drip Pan
PartSelect #: PS12667281
Manufacturer #: 7725P006-60
Bowl, drip
No Longer Available
Gas Burner & Control Valve
PartSelect #: PS12691809
Manufacturer #: 7502P081-60
Valve, top burner-re
No Longer Available
Questions And Answers for SF9611KA570R
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
pilot lit but oven would light
replaced the oven safety valve. This device uses heat from the pilot to hold open a valve that allows gas from the thermostat control to feed the main burner. It works by boiling the liquid mercury in the sensor bulb, producing the pressure to hold open the valve. My sensor had failed from old age, leaking the mercury.
Spill ... Read more ed mercury needed to be collected and properly disposed, and the valve was a tough fit among the sheet metal parts that form the path for the gas to the burner slots. The valve is secured by flat head sheet metal screws and the gas plumbing is a tapered pipe fitting. The sensor bulb has a small steel spring to hold it in the proper spot to sense the pilot light.
I used gas-rated pipe dope on the gas fitting, probably unnecessarily. Valve faces only 1/2 psi pressure...
Spill ... Read more ed mercury needed to be collected and properly disposed, and the valve was a tough fit among the sheet metal parts that form the path for the gas to the burner slots. The valve is secured by flat head sheet metal screws and the gas plumbing is a tapered pipe fitting. The sensor bulb has a small steel spring to hold it in the proper spot to sense the pilot light.
I used gas-rated pipe dope on the gas fitting, probably unnecessarily. Valve faces only 1/2 psi pressure...
Read less
Parts Used:
-
Paul from Arlington, MA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers, Wrench set
19 of 26 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!