Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
The Upper Boom Assembly by Ryobi is a key component designed for the smooth functioning of your tool. This product is crafted carefully, ensuring every proprietors' longevity and durability expectatio...
This spool retainer is sourced from the equipment manufacturer for use in trimmers. It is a plastic knob, measuring 2 inches in diameter, with a threaded metal bolt in the center. The retainer has a r...
This grass deflector acts like a shield so that grass clippings are directed away from you and the surrounding areas while you are operating your trimmer. It is often located near the bottom of your t...
Introducing a superb addition to your tool kit - the Ryobi Fuel Tank with Cap. This high-quality product is designed and built by Ryobi, a renowned brand known for its long-lasting tools and parts. Th...
This OEM spring, also known as a recoil or rewind spring, is housed in a container and is used to retract the starter rope on various lawn equipment models. Over time and through use, the spring will ...
Springs are used within outdoor power equipment to provide tension and shock absorption, depending on their application and use. This spring is designed for use within trimmers/brush cutters and is ma...
This is a genuine manufacturer-sourced component that is specially designed for use with Ryobi, Ridgid and Homelite equipment. It is an identical replacement for a missing or faulty switch that was or...
This replacement gasket is an authentic OEM item that is specially designed for Ryobi lawn and garden equipment. This gasket provides an air-tight seal for the oil pan. Over time gaskets tend to shrin...
This carburetor is for line trimmers.
Carburetor mixes air and gas before the fuel mix goes to the engine.
Wear work gloves to protect your hands and work in a well-ventilated area during this repair.
This is an OEM sourced replacement part used on gas trimmers. A centrifugal clutch is a part that uses centrifugal force to connect two concentric shafts, with the driving shaft nested inside the driv...
Genuine OEM replacement part, this item is sold individually. This is the part of the trimmers listed below that the cutting line is installed in. This spool uses .095 diameter cutting line. If you wo...
No Longer Available
Questions And Answers for RY34425
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Remove carb cover, remove 2 t25 torx head screws. ( they are loctite in so they may be difficult). flip up carb, install new carb. swap gas fill and return lines to carb. choke and start, go to work.
Once I was able to see the problem. I had to make modifications so it could be used. It took awhile to figure out the problems. With a drill motor and metal bit I was able to get the boom where I could use it.
