RTW4640YQ0 Roper Washer - Overview

Hello Travis, thank you for your question. We would recommend checking the PartSelect Number: PS11703290 suspension rods, and if they are in working order the issue is probably the drive block PartSelect Number: PS11741977. I hope this helps!

Hi Pam, Thank you for your question. If your washer starts filling with water and then immediately goes to the spin cycle, there is an issue with the electronic control board and it will need to be replaced. The part number listed under your model number for the electronic control board is PS4704668. If you would like to place an order for it, you may order it either online or by calling our customer service line and anyone will be happy to assist you. We hope this helps! If you have any questions, please let us know.

Hi Mark, thank you for your inquiry. We suggest you take a close look at the water inlet valve to check whether its screens are clogged or not. Clean the screens. Try disconnecting the hoses on the back of the machine and cleaning the screen in the inlets. If this does not help, we recommend replacing the water inlet valve, part number PS11757114. We hope this information helps!

Hi Herman, Thank you for your question. If your washer still shakes and moves after replacing the suspension rods, you will likely need to replace the suspension springs. These springs help the tub maintain proper alignment. If they are damaged or worn, they will need to be replaced. You should also make sure that the washer is level and that you are not overloading the washer as this may also cause the washer to shake and move. We hope this helps!

Hello Thomas, thank you for asking. We suggest checking for any obstructions between the tub and drum first. You can also check the drive block, spanner nut and tub seal for wear or damage. If they are good, you may have a damaged gearcase, washer drive pulley or belt. We hope this information is useful!