Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This evaporator fan motor is in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated. When the evaporator ...
This Samsung hex screw is a genuine OEM replacement fastener that is designed for the refrigerator door handle. It is a stainless steel screw that secures the handle to the refrigerator door. It is re...
This is a crisper drawer for models of Samsung refrigerators. Crisper drawers are used to store fruits and vegetables at a different humidity level from the rest of the fridge to preserve their freshn...
This roller wheel axle pin (part number DA61-01920A) is for refrigerators. Roller wheel axle pin DA61-01920A attaches the roller wheel to the roller wheel bracket. Wear work gloves to protect your han...
This manufacturer-approved screw is for refrigerators, including Kenmore refrigerator model. Avoid cross-threading refrigerator screw during installation.
Remove shelves then at bottom is a cover that holds fan in place remove a total of 6 screws. 2 of them are behind lamp lens cover you have to remove lamp lens to see them. Then use hair dryer to melt ice to allow cover to come off. Slow remove cover top left side there are two connector you have to disconnect. Then there are 4 screw to pu
... Read morell fan Assy from cover. 1 screw to get to fan motor.on fan cage remove coil spring then pull cage of . Then unplug connector from fan motor. Note to clean drain hole I use a small hose/ funnel and warm water to open hole back up.
