Models > RF23HTEDBSR > Instructions

RF23HTEDBSR (FA) Samsung Refrigerator - Instructions

All Instructions for the RF23HTEDBSR

Evaporator frozen (refrigrator section) and allowing top section to lose cooling

This is the Samsung French door refrigerator style that so many people have complained about freezing up and not cooling the top section. I first changed out the defrost thermostat and this did not correct the problem. I done a quick resistance check on the temp sensor that's mounted on the evaporator itself. The resistance would change when holding an ice cube on the sensor so I just assumed it was ok. PLEASE TAKE NOTE: When performing a resistance check on this sensor, make sure your readings match the Samsung temp/resistance chart in their literature. My sensor was way off calibration and was causing the freeze up. Its working as designed now and DW is happy again. Learn from my mistake.

Parts Used:

Temperature Sensor

Richard from GULFPORT, MS
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

96 of 155 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Old gasket shrunk and let air in and freezer frosted over

Remove old gasket-just pulled off.
Pushed on new gasket- easy peasy.

Parts Used:

Refrigerator Freezer Door Gasket

Frederick from Indianapolis, IN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Refrigerator was too cold - down to 18 degrees Fahrenheit.

Removed shelves. Removed back cover. Removed old sensor. Installed new sensor. Replaced back cover. Replaced shelves. Works fine.

Parts Used:

Temperature Sensor

Bill from RALEIGH, NC
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

5 of 14 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

We misplaced the mounting screws for our handles while moving.

It was easy! I just used an alan wrench to losen the side bolt, then slid the handle into the new mounting screws that I had hand-screwed and then tightened it all up.

Parts Used: